No abstract

No abstract

Production of green chemicals using a biomass derived feedstock is of current interest. Among the processes, the hydrogenolysis of glycerol to 1,2-propanediol (1,2-PD) using externally supplied molecular hydrogen has been studied quite extensively. The utilization of methanol present in crude glycerol from biodiesel production can avoid the additional cost for molecular hydrogen storage and transportation, as well as reduce the safety risks due to the high hydrogen pressure operation. Recently the hydrogenolysis of glycerol with a Cu/ZnO/Al2O3 catalyst using in situ hydrogen generated from methanol steam reforming in a liquid phase reaction has been reported. This paper focusses on the effect of added Ni on the activity of a Cu/ZnO/Al2O3 catalyst prepared by an oxalate gel-co-precipitation method for the hydrogenolysis of glycerol using methanol as a hydrogen source. It is found that Ni reduces the conversion of glycerol but improves the selectivity to 1,2-PD, while a higher conversion of methanol is observed. The promoting effect of Ni on the selectivity to 1,2-PD is attributed to the slower dehydration of glycerol to acetol coupled with a higher availability of in situ hydrogen produced from methanol steam reforming and the higher hydrogenation activity of Ni towards the intermediate acetol to produce 1,2-PD.

The glycerol hydrogenolysis to produce 1,2-propanediol without using externally supplied hydrogen was investigated using methanol present in crude glycerol to provide in situ hydrogen via its steam reforming reaction. This paper focuses on the promoting effect of Pd on the reactivity of a Cu/Zn/Al2O3 catalyst. Adding 2 wt% Pd onto a Cu/ZnO/Al2O3 catalyst significantly improved the selectivity to 1,2-propanediol from 63.0% to 82.4% and the glycerol conversion from 70.2% to 99.4%. This enhancement on the catalytic activity by Pd is mainly due to the improved hydrogenation of acetol, which is the intermediate formed during the glycerol dehydration. The rapid hydrogenation of acetol can shift the reaction equilibrium of glycerol dehydration forward resulting in a higher glycerol conversion. The improved reducibility of the catalyst by Pd allows the catalyst to be reduced in situ during the reaction preventing any loss of catalyst activity due to any potential oxidation of the catalyst. The catalyst was slightly deactivated when it was firstly recycled resulting in a 5.4% loss of glycerol conversion due to the aggregation of Cu and the deactivation became less noticeable upon further recycling.

The catalytic process of glycerol hydrogenolysis to produce 1,2-propandiol (1,2-PD) in the absence of external hydrogen addition has been investigated. The methanol present in the crude glycerol from a biodiesel production process is used to provide in situ hydrogen produced via methanol steam reforming for the glycerol hydrogenolysis process. This process can reduce the additional cost for the transportation and storage of molecular hydrogen and also reduce the safety risks related to using high hydrogen pressure. It was found that the introduction of Pd onto a Cu/MgO/Al2O3 catalyst significantly improved the glycerol conversion and 1,2-PD selectivity. The pseudo-first-order kinetic results suggested that the promoting effect of Pd is primarily attributed to the enhanced activity for the hydrogenation of acetol, which is the intermediate formed via glycerol dehydration. A 27−3 fractional factorial design experiment was carried out to investigate the impacts of seven single factors and their binary effects on two responses, namely 1,2-PD selectivity and glycerol conversion. The results showed that the glycerol feed concentration has the most significant effect on the 1,2-PD selectivity, such that the 1,2-PD selectivity is lower if a more concentrated glycerol is used as the feedstock; stirring speed, inert gas pressure and water to methanol molar ratio have insignificant effects on the reaction system. The addition of Pd, higher temperature and higher catalyst loading are the essential factors in order to obtain a high selectivity of 1,2-PD and a high glycerol conversion.