The structural fracture of the compressor blade is the main cause of fatigue failure. The novelty of this paper is the creative application of bent swept-back modeling to the blade of the turbocharger impeller. This paper is based on a compressor impeller satisfying the k-ε turbulence model. A simulation model was established in ANSYS software, the fluid–structure interaction was calculated in the three models before and after improvement, and the results were compared and analyzed. The optimized blade could improve the blade structure, reduce stress and deformation, and improve the pressurization ratio. In this paper, the optimization scheme of different parameters was discussed in line with the optimal solution. Based on the combination of fuzzy and grey correlation theory, it was concluded that the correlation between pressure and total deformation was higher than that of equivalent stress, and these two values reached 0.8596 and 0.8001, respectively. The results showed that the pressure and total deformation were significantly related to the flow rate. It provides a feasible scheme for further improvement of the supercharger compressor.

No abstract