No abstract

No abstract

The precipitation of TiN inclusion during solidification of different carbon content of 0.72%, 0.82% and 0.95% in tire cord steel is thermodynamically studied respectively. The results show that the carbon content has obvious effect on TiN inclusion precipitated in tire cord steel of different strength levels. With the carbon content of tire cord steel increasing, the temperature before solidifying reduced gradually and the required activity product of titanium and nitrogen for TiN inclusion precipitation also declined gradually. With the same condition of initial Ti and N content in liquid steel, the size of TiN inclusion precipitated in tire cord steel of higher carbon content is bigger than that of lower carbon content. In order to control the harmful effects on processability of TiN inclusion precipitated in hypereutectoid tire cord steel of the ultra high strength level, the measures of smelting process must be taken to further reduce the titanium and nitrogen content in liquid steel.

In order to improve the quality of the cord steel wire rod and achieve the effective control of titanium inclusion, the solid solution behavior of titanium inclusion in tire cord steel during the heating process was discussed in this paper, through the thermodynamic theory analysis, combined with the CLSM experiment. The conclusions are as follows: 1) According to the law of Ostwald repening, the coarsening rate of titanium carbonitride inclusion is very small, the coarsening behavior of titanium carbonitride inclusion cannot be considered in the heating and holding stage. 2) The solid solution behavior of titanium inclusion in the heating process is obviously existed. 3) Through the proper control of rolling temperature, holding time and the subsequent cooling rate, the size and quantity of large particle titanium inclusion in the high strength tire cord steel can be effectively controlled.

The application of Nb microalloying to high-carbon pearlite bridge cable wire rod steel has always been controversial, especially in the actual production process, which will be affected by the cooling rate, holding temperature and final bonding temperature. In this paper, the experimental characterization, finite element simulation and phase diagram calculation of the test steel were carried out, then the microstructure and properties of different parts of Nb microalloying of bridge cable wire rods were compared and analyzed. The phase transition interval of pearlite during the water-cooling process of bridge cable wire rods is increased due to the refinement of austenite grains, and the significant increase in the end temperature of the phase transition makes the average interlamellar spacing of pearlite increase. The cooling rate of different parts of bridge cable wire rods simulated by Abaqus has little difference. At the same time, Nb microalloying effectively increases the proportion of low-angle grain boundaries, so that the overall average misorientation representing the surface defects is reduced. This helps to reduce the surface energy and increase the stability of the microstructure. Combined with the mechanical properties of microtensile rods, it is found that the grain refinement effect of Nb is greater than that of coarsening interlamellar spacing during hot rolling deformation in actual production, which makes the tensile strength at the 1/4 section increase significantly. The overall tensile strength and area shrinkage of the steel wire have also been effectively improved.