Automatic Transfer Switch (ATS) is a device that can move the main power source to a backup power source automatically and quickly when the main power source is interrupted or the supply cuts to the load. In this study, ATS was designed based on the Arduino Nano microcontroller as an automatic control that works based on voltage readings. Using the Arduino Nano microcontroller can facilitate the process of making tools and minimize the use of components. This ATS uses the PZEM-004T voltage sensor module. The voltage sensor module functions to detect and measure the value of the PLN voltage. From the test results, it was found that the time lag between the PLN supply being cut off until the battery was supplying and ready to be loaded was an average of 2.79 seconds. Meanwhile, the time lag when the PLN supply turns on again until the battery supply is cut off and the load supply is again served by PLN is 3.07 seconds on average. Other tests found that in measuring battery resistance with a load of 20 watts, the current obtained is 1.66 amperes with a usage resistance of 27 hours, while when the load is 200 watts the current is 16.66 amperes while the resistance to use is 2.7 hours. The length of battery life is affected by the magnitude of the load.
This study was conducted to obtain the angle of elevation of solar panels (PV) to harvest photon light energy sources from LED bulbs that are often used in residential homes or buildings. The PV tilt angles tested are 0, 15, 30 and 90º by placing a constant bulb in its position. The results of the observations show that a slope of 0º produces the highest PV electrical power, although it is not significant compared to the other 3 slope angles. The decrease in PV output power occurs when the slope angle increases. Optimum power of 16.93 Watt is obtained by using a Hannochs bulb at a power of 15 Watt with an angle of elevation of 0º. Furthermore, the power decreased to 16.33, 12.92, and 12.91 Watts at angles of 15, 30 and 90º, respectively. Further research is still needed by increasing the variation of bulb power above 15 Watts to validate the position of the PV panels on the walls of the building according to light source.
Heat transfer is the transfer of energy from one area to another due to the temperature difference between these areas. Wasted heat energy can be converted into electricity using (TEG) between the hot and cold sides. If the temperature difference is more significant, the efficiency may increase along with the operating temperature of the TEG-type material. So in this study, the author will calculate the heat transfer that occurs in Photovoltaic (PV), Thermoelectric Generator (TEG), and Hot Mirrors by utilizing thermal energy light produced from Muxindo LED bulbs with 10 Watt, 15 Watt, and 20 Watt power. The results of this study indicate that by using 10, 15, and 20 Watt LED bulbs for free convection heat transfer, the power generated from each point increases because it passes through several obstacles from objects that experience a decrease in temperature to PV and TEG, with the characteristics of the displacement. The movement of molecules from the medium importance follows convection heat at every point of transfer in the intermediate substance. The most significant power generated from radiant heat transfer is about 0.1873 Watt. It occurs on the surface of the fresnel lens using a 20 Watt LED bulb with the characteristic that the radiation propagates in a straight line and does not require an intermediate medium to transfer heat from one substance to another. The most significant conduction heat transfer power, 0.2453 Watt, occurs in Fresnel Lens using a 20 Watt LED bulb with heat transfer characteristics in solid objects.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.