No abstract

Horizontal wells’ multi-section and multi-cluster hydraulic fracturing plays an important role in the efficient development of shale gas. However, the influence of the perforating hole and natural fracture dip angle on the process of hydraulic fracture initiation and propagation has been ignored in the current researches. This paper presents the results related to a tri-axial large-scale hydraulic fracturing experiment under different natural fracture parameters. We discuss the experimental results relating to the near-wellbore tortuosity propagation of hydraulic fractures. Experimental results showed that the triaxial principal stress of the experimental sample was deflected by the natural fracture, which caused significant near-wellbore tortuosity propagation of the hydraulic fractures. The fractures in most rock samples were not perpendicular to the minimum horizontal principal stress after the experiment. As well, the deflection degree of triaxial principal stress direction and the probability of hydraulic fractures near-wellbore tortuosity propagation decreased with the increase of the natural fracture dip angle. After hydraulic fractures’ tortuous propagation, the hydraulic fractures will propagate in the direction controlled by the triaxial stress in the far-wellbore area. For reservoirs with natural fractures, proppant in hydraulic fracturing should be added after the fractures are fully expanded to prevent sand plugging in tortuous fractures. When the permeability of natural fractures is low, the volume of fracturing fluid entering natural fractures is small, and hydraulic fractures are easy to pass through the natural fractures.

Shale gas reservoirs are unconventional resources with great potential to help meet energy demands. Horizontal drilling and hydraulic fracturing have been extensively used for the exploitation of these unconventional resources. According to engineering practice, some shale gas wells with low flowback rate of fracturing fluids may obtain high yield which is different from the case of conventional sandstone reservoirs, and fracturing fluid absorbed into formation by spontaneous imbibition is an important mechanism of gas production. This paper integrates NMR into imbibition experiment to examine the effects of fractures, fluid salinity, and surfactant concentration on imbibition recovery and performance of shale core samples with different pore-throat sizes acquired from the Longmaxi Formation in Luzhou area, the Sichuan Basin. The research shows that the right peak of T2 spectrum increases rapidly during the process of shale imbibition, the left peak increases rapidly at the initial stage and changes gently at the later stage, with the peak of the left peak shifting to the right. The result indicates that water first enters the fracture system quickly, then enters the small pores near the fracture wall due to the effect of the capillary force, and later gradually sucks into the deep and large pores. Both imbibition rate and capacity increase with increased fracture density, decreased solution salinity, and decreased surfactant concentration. After imbibition flowback, shale permeability generally increases by 8.70–17.88 times with the average of 13.83 times. There are also many microcracks occurring on the end face and surface of the core sample after water absorption, which may function as new flowing channels to further improve reservoir properties. This research demonstrates the imbibition characteristics of shale and several relevant affecting factors, providing crucial theory foundations for the development of shale gas reservoirs.

Gas reservoir numerical simulation is an important method to optimize the development strategy of shale gas reservoirs which has been influenced by the multi-stage fracture. The regular fracture network model was used to build a conventional numerical simulation, in which it was difficult to show the true situation of fracture propagation. However, the physical parameters not only affect the production, but also influence the stimulation effect; moreover, the quality of the fracturing effect also affects the production which causes the input and out parameters to be inaccurate. To solve this problem, the process simulation must be completed from geology to engineering to gas reservoir. The main controlling factors of production are identified with geological and engineering factors such as horizontal stage length, the volume of fracturing fluid, well spacing, production allocation, and proppant mass. Therefore, on the basis of the integrated simulation method of a hydraulic fracturing network simulation and an unstructured grid high-precision numerical simulation, this paper builds an integrated numerical simulation of a shale gas reservoir coupled with geology and engineering to optimize the development strategy with production as the target. Taking four wells of a platform as an example, the EUR (estimated ultimate recovery) has increased by 25% after the optimization of the development strategy.

No abstract