The formation of lithium dendrites is suppressed using a Li1.5Al0.5Ge1.5(PO4)3–poly­(ethylene oxide) (LAGP-PEO) composite solid electrolyte and a PEO (lithium bis­(trifluoromethane)­sulfonimide) [PEO (LiTFSI)]-modified lithium metal anode in all-solid-state lithium batteries. The effects on the anode performance based on the PEO content in the composite solid electrolyte and the molecular weight of PEO used to modify the Li anode are studied. The structure, surface morphology, and stability of the composite solid electrolyte are examined by X-ray diffraction spectroscopy, scanning electron microscopy, and electrochemical tests. Results show that the presence of a PEO-500000­(LiTFSI) film on a Li anode results in good mechanical properties and satisfactory interface contact features. The film can also prevent Li from reacting with LAGP. Furthermore, the formation of lithium dendrites can be effectively inhibited as the composite solid electrolyte is combined with the PEO film on the Li anode. The ratio of PEO in the composite solid electrolyte can be reduced to a low level of 1 wt %. PEO remains stable even at a high potential of 5.12 V (vs Li/Li+). The assembled Li-PEO (LiTFSI)/LAGP-PEO/LiMn0.8Fe0.2PO4 all-solid-state cell can deliver an initial discharge capacity of 160.8 mAh g–1 and exhibit good cycling stability and rate performance at 50 °C.

No abstract

No abstract

High nickel content in LiNixCoyMnzO2 (NCM, x ≥ 0.8, x + y + z = 1) layered cathode material allows high specific energy density in lithium-ion batteries (LIBs). However, Ni-rich NCM cathodes suffer from performance degradation, mechanical and structural instability upon prolonged cell cycling. Although the use of single-crystal Ni-rich NCM can mitigate these drawbacks, the ion-diffusion in large single-crystal particles hamper its rate capability. Herein, we report a strategy to construct an in situ Li1.4Y0.4Ti1.6(PO4)3 (LYTP) ion/electron conductive network which interconnects single-crystal LiNi0.88Co0.09Mn0.03O2 (SC-NCM88) particles. The LYTP network facilitates the lithium-ion transport between SC-NCM88 particles, mitigates mechanical instability and prevents detrimental crystalline phase transformation. When used in combination with a Li metal anode, the LYTP-containing SC-NCM88-based cathode enables a coin cell capacity of 130 mAh g−1 after 500 cycles at 5 C rate in the 2.75-4.4 V range at 25 °C. Tests in Li-ion pouch cell configuration (i.e., graphite used as negative electrode active material) demonstrate capacity retention of 85% after 1000 cycles at 0.5 C in the 2.75-4.4 V range at 25 °C for the LYTP-containing SC-NCM88-based positive electrode.