Objectives To evaluate changes in dimensions and volume of upper airway before and after mini-implant assisted rapid maxillary expansion (MARME) and observe correlations between changes of upper airway and vertical skeletal pattern in young adults. Materials and Methods In this retrospective study, 22 patients (mean age, 22.6 ± 4.5 years; 4 male 18 female) with transverse discrepancy underwent MARME. Cone beam computed tomography was taken before and 3 months after expansion. Vertical and horizontal dimensions and volume of the nasal cavity, nasopharyngeal, retropalatal, retroglossal and hypopharyngeal airway were compared before and after MARME. Correlations between changed volume and dimensions were explored, as well as the vertical skeletal pattern. Results Nasal osseous width, maxillary width, volume of the nasal cavity and nasopharynx increased significantly (P < .05). Enlarged nasopharyngeal volume correlated with increased nasal width at the PNS plane (P < .05). There were no correlations between expanded volume and maxillary width. No measurements except nasal cavity volume had a correlation with Sum angle. Increased maxillary width correlated negatively with hard palate thickness (P < .05). Conclusions (1) MARME caused an increase in volume of the nasal cavity and nasopharynx, with expansion of nasal osseous width and maxillary width. (2) Enlarged nasal width at the PNS plane contributed to the increase in nasopharynx volume. Enlarged maxillary width showed no direct relation with increased volume. (3) In this study, it was unclear about the association between changes of the upper airway and vertical skeletal pattern because of complex structures. (4) Palate thickness affected skeletal expansion of the maxilla in MARME.

This study evaluated the effect of cavity design on stress distribution and fracture resistance of direct composite resin restorations in Class IV preparations. A finite element analysis (FEA) model of the maxillary central incisor with a Class IV cavity was established. Five model variations were studied: (i) a 1-mm bevel (ii) a 2-mm bevel, (iii) a plain chamfer, (iv) a stair-step chamfer, and (v) butt joints (a control configuration). All FEA variations modeled a tooth restored with composite resin loaded under 100 N at an angle of 45° to the longitudinal axis. The interfacial von Mises stress was evaluated. The FEA was complemented with an in vitro assessment. Fracture resistance of direct composite resin restorations was tested with a universal testing machine and fracture patterns were observed. Finite element analysis showed that stress in chamfer and stair-step chamfer models was more homogenously distributed, while stress in bevel models was relatively concentrated at lingual regions. Fracture resistance of a 1-mm bevel preparation was lower than for the 2-mm bevel, plain chamfer, and stair-step chamfer preparations, but was higher than for butt joints. The stair-step chamfer group presented the most favorable failure pattern. Considering biomechanics and esthetics, the present study indicates that the stair-step chamfer and 2-mm bevel should be recommended for clinical restoration.

No abstract