Small perturbations and strong impurity exhaust capability associated with the small grassy ELMs render the grassy-ELM regime a suitable candidate for achieving steady-state H-mode operation with a radiative divertor, especially in a metal-wall device, such as the Experimental Advanced Superconducting Tokamak (EAST). As the degradation of pedestal performance with excessive divertor impurity seeding or accumulation tends to be accompanied with significantly increased radiation near the divertor X point, feedback control of the absolute extreme ultraviolet (AXUV) radiation near the X point has been employed to maintain the confinement property in EAST. However, the absolute value of the AXUV radiation at the outer target varies with plasma conditions as during the divertor detachment process. Thus, a new feedback-control scheme has been recently developed and applied to grassy-ELM H-mode plasmas in EAST to achieve stationary partial detachment while maintaining good global energy confinement with H 98,y2 >1. In this scheme, electron temperatures (T et) measured by divertor Langmuir probes are used to identify the onset of detachment, and then the plasma control system (PCS) switches to the feedback control of one channel of AXUV radiation near the X point, where a steep gradient in the radiation profile is present. The feedback is performed through pulse-width-modulated duty cycle of a piezo valve to seed impurities with mixed gas (50% Ne and 50% D2) from the outer target plate near the strike point in the upper tungsten monoblock divertor. T et near the strike point is maintained in the range of 5–8 eV, and peak surface temperature on the outer target plate (T IR,peak) is suppressed and maintained at ∼180 °C, based on infrared camera measurements. The plasma stored energy maintains nearly constant over the entire feedback-control period. It thus offers a highly promising plasma control scenario suitable for long-pulse high-performance H-mode operation in EAST, which is potentially applicable to future steady-state fusion reactors as an integrated solution for the control of both ELM-induced transient and steady-state divertor heat loads while maintaining good core confinement.

Tungsten rods of 1×1×3mm were exposed in single H-mode discharges at the outer divertor target plate of ASDEX Upgrade using the divertor manipulator system. Melting of the W rod at a pre-defined time was induced by moving the initially far away outer strike point close to the W-rod position. Visible light emission of both the W-pin and consecutively ejected W droplets were recorded by two fast cameras with crossed viewing cones. The time evolution of the local W-source at the pin location was measured by spectroscopic observation of the WI line emission at 400.9 nm and compared to the subsequent increase of the tungsten concentration in the confined plasma derived from tungsten vacuum UV line emission.Combining these measurements with the total amount of released tungsten due to the pin melt events and ejected droplets allowed to derive an estimate of the screening factor for this type of tungsten source. The resulting values of the tungsten divertor retention in the range from 10-20 agree with those found in previous studies using a W-source of sublimated W(CO) 6 vapour at the same exposure location. Ejected droplets were found to be always accelerated in general direction of the plasma flow, attributed to friction forces and to rocket forces. Furthermore, the vertically inclined target plates cause the droplets, which are repelled by the target plate surface potential due to their electric charge, to move upwards against gravity due to the centrifugal force component parallel to the target plate.

The ASDEX Upgrade (AUG) programme, jointly run with the EUROfusion MST1 task force, continues to significantly enhance the physics base of ITER and DEMO. Here, the full tungsten wall is a key asset for extrapolating to future devices. The high overall heating power, flexible heating mix and comprehensive diagnostic set allows studies ranging from mimicking the scrape-off-layer and divertor conditions of ITER and DEMO at high density to fully non-inductive operation (q 95  =  5.5, ) at low density. Higher installed electron cyclotron resonance heating power   6 MW, new diagnostics and improved analysis techniques have further enhanced the capabilities of AUG. Stable high-density H-modes with MW m−1 with fully detached strike-points have been demonstrated. The ballooning instability close to the separatrix has been identified as a potential cause leading to the H-mode density limit and is also found to play an important role for the access to small edge-localized modes (ELMs). Density limit disruptions have been successfully avoided using a path-oriented approach to disruption handling and progress has been made in understanding the dissipation and avoidance of runaway electron beams. ELM suppression with resonant magnetic perturbations is now routinely achieved reaching transiently . This gives new insight into the field penetration physics, in particular with respect to plasma flows. Modelling agrees well with plasma response measurements and a helically localised ballooning structure observed prior to the ELM is evidence for the changed edge stability due to the magnetic perturbations. The impact of 3D perturbations on heat load patterns and fast-ion losses have been further elaborated. Progress has also been made in understanding the ELM cycle itself. Here, new fast measurements of and E r allow for inter ELM transport analysis confirming that E r is dominated by the diamagnetic term even for fast timescales. New analysis techniques allow detailed comparison of the ELM crash and are in good agreement with nonlinear MHD modelling. The observation of accelerated ions during the ELM crash can be seen as evidence for the reconnection during the ELM. As type-I ELMs (even mitigated) are likely not a viable operational regime in DEMO studies of ‘natural’ no ELM regimes have been extended. Stable I-modes up to have been characterised using -feedback. Core physics has been advanced by more detailed characterisation of the turbulence with new measurements such as the eddy tilt angle—measured for the first time—or the cross-phase angle of and fluctuations. These new data put strong constraints on gyro-kinetic turbulence modelling. In addition, carefully executed studies in different main species (H, D and He) and with different heating mixes highlight the importance of the collisional energy exchange for interpreting energy confinement. A new regime with a hollow profile now gives access to regimes mimicking aspects of burning plasma conditions and lead to nonlinear interactions of energetic particle modes despite the sub-Alfvénic beam energy. This will help to validate the fast-ion codes for predicting ITER and DEMO.