The aim of this study was to investigate the characteristics of unilateral tibial plateau fractures among hospitalized adult patients in Xijing Hospital, to evaluate the accuracy of Schatzker classification system and AO/OTA classification system to tibial plateau fractures. We retrospectively analysed clinical data on 274 patients admitted to Xijing Hospital between September 2006 and August 2015. The patients’ demographic characteristics, admission periods and seasons, external causes and fracture types were recorded and summarized. Then the characteristics of tibial plateau fractures and the accuracy rate of these two classification systems were analysed. Schatzker type II fractures and AO/OTA type 41-B3 fractures were the most common types. The external causes differed between genders, types of employment, urban-rural residents and both two systems. In addition, some fractures were difficult to classify using Schatzker or AO/OTA classification system. Rural male physical labourers aged between 30–59 years-old were most likely to suffer from unilateral tibial plateau fractures, due to traffic accidents, falls and indoor activity injuries, or falls from height. We should pay more attention to the related people and professions, which contributed to the high occurrence of tibial plateau fractures. Besides that, further improvements are required for both Schatzker and AO/OTA classification systems.

Ankle fracture is one of the most common traumatic fractures among the elderly population. The majority of ankle fractures are stable types with the typically conservative strategy of close contact casting treatment. The continuous use of unventilated standard cast immobilization severely affects patient’s satisfaction and compliance and markedly increases the rates of various complications. Three-dimensional (3D) printing for casts has advantages of lightweight, ventilated, proper-fit, and esthetic improvements. In this work, this novel 3D-printed cast has been applied to individuals with stable ankle fractures, and its effectiveness can be successfully validated with finite element analysis and a pilot study. A 30% reduction of the volume was chosen as the optimal result in topology optimization. Both 3D-printed casts and conventional casts showed significant ankle function improvement after immobilization for 6 weeks (p = 0.000). The 3D-printed casts were superior to the traditional casts in Olerud–Molander Ankle Scores (OMAS), with the mean difference of 8.3 ± 8.57 OMAS points (95% CI −10.8 to 27.5; p = 0.354) for 6 weeks, implying that the 3D-printed casts possibly maintain the equal clinical efficacy as the traditional casts. The statistically significant difference between groups from the 3D-printed cast and the traditional one observed in C-QUEST 2.0 was 11.3 ± 1.5 points (95% CI 8.0–14.6; p = 0.000), indicating that the 3D-printed cast possesses outperforming satisfaction and compliance and has great potential in practical applications. There were no severe complications in the 3D-printed casts, but more moderate complications were observed in the traditional casts.