Compared to the common selective laser sintering (SLS) manufacturing method, fused deposition modeling (FDM) seems to be an economical and efficient three-dimensional (3D) printing method for high temperature polymer materials in medical applications. In this work, a customized FDM system was developed for polyether-ether-ketone (PEEK) materials printing. The effects of printing speed, layer thickness, printing temperature and filling ratio on tensile properties were analyzed by the orthogonal test of four factors and three levels. Optimal tensile properties of the PEEK specimens were observed at a printing speed of 60 mm/s, layer thickness of 0.2 mm, temperature of 370 °C and filling ratio of 40%. Furthermore, the impact and bending tests were conducted under optimized conditions and the results demonstrated that the printed PEEK specimens have appropriate mechanical properties.

No abstract

Wire and Arc Additive Manufacturing (WAAM) was used for fabrication of NiTi parts using a commercialy available Ni-rich NiTi wire as the feedstock material. The as-built parts are near fully austenitic at room temperature as confirmed by differential scanning calorimetry, X-ray diffraction and superelastic cycling. The as-built microstructure changed from collumnar, in the first deposited layers, to equiaxed in the last deposited ones as a result of the different thermal cycle conditions. This is the 2 first work where WAAM NiTi parts exhibit superelastic behavior under tensile conditions, highlighting the potential use of the technique for the creation of parts shaped in a complex manner based on this material and process. The potential to use WAAM for deposition of advanced functional materials is demonstrated.

No abstract