With the third innovation in science and technology worldwide, China has also experienced this marvelous progress. Concerning the longwall mining in China, the "masonry beam theory" (MBT) was first proposed in the 1960s, illustrating that the transmission and equilibrium method of overburden pressure using reserved coal pillar in mined-out areas can be realized. This forms the so-called "121 mining method", which lays a solid foundation for development of mining science and technology in China. The "transfer rock beam theory" (TRBT) proposed in the 1980s gives a further understanding for the transmission path of stope overburden pressure and pressure distribution in high-stress areas. In this regard, the advanced 121 mining method was proposed with smaller coal pillar for excavation design, making significant contributions to improvement of the coal recovery rate in that era. In the 21st century, the traditional mining technologies faced great challenges and, under the theoretical developments pioneered by Profs. Minggao Qian and Zhenqi Song, the "cutting cantilever beam theory" (CCBT) was proposed in 2008. After that the 110 mining method is formulated subsequently, namely one stope face, after the first mining cycle, needs one advanced gateway excavation, while the other one is automatically formed during the last mining cycle without coal pillars left in the mining area. This method can be implemented using the CCBT by incorporating the key technologies, including the directional pre-splitting roof cutting, constant resistance and large deformation (CRLD) bolt/anchor supporting system with negative Poisson's ratio (NPR) effect material, and remote real-time monitoring technology. The CCBT and 110 mining method will provide the theoretical and technical basis for the development of mining industry in China.

The changes associated with the cutting roof and release pressure mining method in the three zones that are susceptible to spontaneous combustion in the goaf with “Y” type ventilation system were studied. For the investigated underground coal mine working face, its three zones of spontaneous combustion have a “U” type ventilation system for the traditional mining method and a “Y” type ventilation system for the cutting roof and release pressure mining method. These systems were monitored using a beam tube method, and the evolution characteristics of spontaneous combustion of the three zones was analysed. The monitoring data showed that when using a traditional mining method with a “U” type ventilation system, the scattered tropical zone converts into the oxidation heating zone after 68.5 m in the goaf, and the suffocative zone presents after 85.5 m. For the cutting roof and release pressure mining method together with a “Y” type ventilation system, the scattered tropical zone converts into the oxidation heating zone after 84 m in the goaf, and the suffocative zone appears after 198.8 m. Compared to traditional mining, the width of the oxidation heating zone increases when using the cutting roof and release pressure method. To prevent spontaneous combustion of the goaf, the comprehensive techniques of the pressure balance for fire control, ground fissure sealing, working face sealing, retained roadways guniting and inert gas fire extinguishing have been used in the studied coal mine. The CO concentration of the goaf is less than 300 ppm during the mining process. Safe mining of the tested working face shows that the cutting roof and release pressure technique can be applied to control the coal seam spontaneous combustion.

No abstract

No abstract