Electromagnetic microwave absorption materials have attracted a great deal of attention. Foams for the low density and tunable porosity are considered as ideal microwave absorbents, while with the requirement of improving their inherent electromagnetic properties. In this manuscript, an innovative, easy, and green method was presented to synthesize an electromagnetic functionalized Ni/carbon foam, in which the formation of Ni nanoparticles and carbon occurred simultaneously from an affordable alginate/Ni(2+) foam precursor. The resultant Ni/carbon foam had a low density (0.1 g/cm(-3)) and high Ni nanoparticles loading (42 wt %). These Ni nanoparticles with a diameter of about 50-100 nm were highly crystallized and evenly embedded in porous graphite carbon without aggregation. Also, the resultant foam had a high surface area (451 m(2) g(-1)) and porosity and showed a moderate conductivity (6 S/m) and significant magnetism. Due to these special characteristics, the Ni/carbon foam exhibited greatly enhanced microwave absorption ability. Only with 10 wt % of functional fillers being used in the test template, the Ni/carbon foam based composite could reach an effective absorption bandwidth (below -10 dB) of 4.5 GHz and the minimum reflection value of -45 dB at 13.3 GHz with a thickness of 2 mm, while the traditional carbon foam and nano-Ni powder both showed very weak microwave absorption (the minimum reflection value < -10 dB). This foam was demonstrated to be a lightweight, high performance, and low filler loading microwave absorbing material. Furthermore, the detailed absorption mechanism of the foam was investigated. The result showed that the derived strong dielectric loss, including conductivity loss, interface polarization loss, weak magnetic loss, and naoporosity, contributes a great electromagnetic absorption.

No abstract

A novel biomass-based mechanically strong and electrically conductive polymer aerogel was fabricated from aniline and biodegradable pectin. The strong hydrogen bonding interactions between polyaniline (PANI) and pectin resulted in a defined structure and enhanced properties of the aerogel. All the resultant aerogels exhibited self-surppoted 3D nanoporous network structures with high surface areas (207-331m(2)/g) and hierarchical pores. The results from electrical conductivity measurements and compressive tests revealed that these aerogels also had favorable conductivities (0.002-0.1 S/m) and good compressive modulus (1.2-1.4 MPa). The aerogel further used as electrode for supercapacitors showed enhanced capacitive performance (184 F/g at 0.5 A/g). Over 74% of the initial capacitance was maintained after repeating 1000 cycles of the cylic voltammetry test, while the capacitance retention of PANI was only 57%. The improved electrochemical performance may be attributed to the combinative properties of good electrical conductivity, BET surface areas, and stable nanoporous structure of the aerogel. Thus, this aerogel shows great potential as electrode materials for supercapacitors.

No abstract

Novel magnetic and conductive Ni/carbon aerogels have been successfully fabricated through an autocatalytic reduction process. The resultant Ni/carbon aerogels have nanoporous structure with high specific surface area, low densities, appropriate electrical conductivities and controllable magnetization. Due to these special attributes, the aerogel composites are demonstrated to be a great microwave absorbent possessing strong and controllable EM absorption with ultrathin thickness. Only with filler loading of 10 wt % in the wax, a minimum RL of −57 dB is found at 13.3 GHz with the thickness of 2 mm. Even with the thickness of 1.5 mm, the Ni/carbon aerogel-3 composite can exhibit the low RL min value of −32 dB and wide effective EM absorption bandwidth of 4.0 dB. The synergistic effect of the medium dielectric loss, weak magnetic loss and good impedance match, accounts for the high microwave absorption performance.