Moderate cooling coprecipitation for monodisperse extremely small iron oxide as a pH dependent T1-MRI contrast agent.

Recently, wood‐based composites have absorbed widespread concern in the field of electromagnetic interference (EMI) shielding due to their sustainability and inherent layered porous structure. The channel structure of wood is often used to load highly conductive materials to improve the EMI shielding performance of wood‐based composites. However, there is little research on how to use pure wood to prepare ultrathin EMI shielding materials. Herein, ultrathin veneer is obtained by cutting wood in parallel to the annual rings. Then, carbonized wood film (CWF) is prepared by a simple two‐step compressing and carbonization. The specific EMI shielding effectiveness (SSE/t) of CWF‐1200 with an ultrathin thickness (140 µm) and high electrical conductivity (58 S cm−1) can reach 9861.41 dB cm2 g−1, which is much higher than other reported wood‐based materials. In addition, the zeolitie imidazolate framework‐8 (ZIF‐8) nanocrystals are grown in situ on the surface of the CWF to obtain CWF/ZIF‐8. CWF/ZIF‐8 exhibits an EMI shielding effectiveness (SE) of up to 46 dB and an ultrahigh SSE/t value of 11 330.04 dB cm2 g−1 in X band. In addition, the ultrathin CWF also shows an excellent Joule heating effect. Therefore, the development of ultrathin wood‐based film provides a research basis for wood biomass to replace traditional non‐renewable and expensive electromagnetic (EM) shielding materials.

Biologically inspired superstructural materials exhibit wide application prospects in many fields, in terms of mitigating increasingly serious electromagnetic (EM) pollution in the civil field. Here, we successfully obtain bamboo slices with uniform pore size distribution through the advanced bamboo transverse splitting technology developed by our group previously and prepare large-scale honeycomb-like carbon-based tubular array (CTA) structures with a controllable pore size, graphitization degree, and selectable conductivity property. Based on the simulation and experimental results, the EM shielding performance of CTAs is proven to be sensitive to the microchannel aperture size and the EM energy incident angle, which is attributed to the difference in the propagation rate of induced electrons in different directions. Among the candidates, CTA-middle-1500 exhibits the best shielding performance against incident EM energy with average SE/ρ values of 123.7 and 144.5 dB cm3 g–1 for perpendicular and parallel directions, respectively, showing its application potential as a lightweight and efficient EM shielding material. The predicted optimal incident angle for CTA-middle-1500 against EM energy radiation is 15°, with the largest RCS reduction value of 26.1 dB m2. The excellent EM shielding performance is attributed to the good reflection capacity involved with the high conductivities of the CTAs.

No abstract

Neural stem cells (NSCs) are used to treat various nervous system diseases because of their self‐renewal ability and multidirectional differentiation potential. However, an insufficient ability to track their migration in vivo and poor control over their survival and differentiation efficiency are two major critical challenges for clinical application. Here, it is shown that when magnetic nanobubbles (MNBs), which are assembled from magnetic nanoparticles, are internalized by NSCs, intramembrane volumetric oscillation of the MNBs induces an increase in intracellular hydrostatic pressure and cytoskeleton force, resulting in the activation of the Piezo1‐Ca2+ mechanosensory channel. This subsequently triggers the BMP2/Smad biochemical signaling pathway, leading to differentiation of NSCs into the neuronal phenotype. Signaling through the Piezo1‐Ca2+‐BMP2/Smad pathway can be further accelerated by application of an external shear stress force using low‐intensity pulsed ultrasound. More importantly, magnetic resonance imaging and ultrasound imaging surveillance of NSCs based on MNB labeling can be leveraged to provide NSC therapeutic outcomes. Both the in vitro and in vivo findings demonstrate that a bubble nanostructure‐induced physical force can modulate and control the mechanical signaling pathway regulating stem cell development.