The reactions between (TPP)AlX, where TPP = tetraphenylporphyrin and X = Cl, O(CH(2))(9)CH(3), and O(2)C(CH(2))(6)CH(3), and propylene oxide, PO, have been studied in CDCl(3) and have been shown to give (TPP)AlOCHMeCH(2)X and (TPP)AlOCH(2)CHMeX compounds. The relative rates of ring opening of PO follow the order Cl > OR > O(2)CR, but in the presence of added 4-(dimethylamino)pyridine, DMAP (1 equiv), the order is changed to O(2)CR > OR. From studies of kinetics, the ring opening of PO is shown to be first order in [Al]. Carbon dioxide inserts reversibly into the Al-OR bond to give the compound (TPP)AlO(2)COR, and this reaction is promoted by the addition of DMAP. The coordination of DMAP to (TPP)AlX is favored in the order O(2)C(CH(2))(6)CH(3) > O(2)CO(CH(2))(9)CH(3) >> O(CH(2))(9)CH(3). The microstructure of the poly(propylene carbonate), PPC, formed in the reactions between (TPP)AlCl/DMAP and (R,R-salen)CrCl and rac-PO/S-PO/R-PO and CO(2), has been investigated by (13)C [(1)H] NMR spectroscopy. The ring opening of PO is shown to proceed via competitive attack on the methine and methylene carbon atoms, and furthermore attack at the methine carbon occurs with both retention and inversion of stereochemistry. On the basis of these results, the reaction pathway leading to ring opening of PO can be traced to an interchange associative mechanism, wherein coordination of PO to the electrophilic aluminum atom occurs within the vicinity of the Al-X bond (X = Cl, OR, O(2)CR, or O(2)COR). The role of DMAP is two-fold: (i) to labilize the trans Al-X bond toward heterolytic behavior, and (ii) to promote the insertion of CO(2) into the Al-OR bond.

Propylene oxide, PO, reacts when heated to 60 °C over a zinc glutarate catalyst to form poly(propylene oxide), PPO, which is regioregular, HTHTHT, and favors isotactic triads ii. Under 50 bar of CO2, poly(propylene carbonate), PPC, is formed with less than 5% polyether linkages and with an even smaller component of propylene carbonate, PC. These reactions have been studied as a function of time, and the products have been analyzed by GPC, MALDI−TOF/MS, and 13C {H} NMR spectroscopy. Polymerization of PO yields PPO with −OH and −H end groups, and in the copolymerization of PO and CO2 the low molecular weight chains are readily identified as an alternating copolymer represented as (PO) n -alt-(CO2) m , where m = n − 1, n − 2, n − 3, n − 4, n − 5, with terminal −OH and −H groups. These results, combined with NMR data, implicate Zn−OH groups as the active initiating species, and furthermore from the molecular weight of the polymer produced at short reaction times, we can infer that some Zn−OH sites are highly active in producing long-chain polymers. The 13C {1H} NMR spectra of PPC formed from rac-PO, 50:50 S-PO + rac-PO, and S-PO reveal the preferential formation of HT junctions in the ring-opening of PO by the alkyl carbonate with a HH:HT:TT ratio of 1:3:1. Certain assignments at the diad, triad, and tetrad levels are offered.

No abstract

The binding of propylene oxide (PO) to a series of metal cations LM(III)(+), where for L = tetraphenylporphyrin (TPP) M = Al, Ga, Cr, and Co, and for L = (R,R)-N,N'-bis(3,5-di-tert-butylsalicylidene)-1,2-cyclohexenediamine (salen) M = Al and Cr, was studied in the gas phase by electrospray tandem mass spectroscopy, and the relative stabilities of LM(PO)(2)(+) and LM(PO)(+) cations were determined. The chromium(III) and aluminum(III) cations most tenaciously bind PO, and for M = Al, coordination to the TPP ligated metal center was favored relative to salen. For (TPP)M(PO)(2)(+), the dissociation of PO followed the order M = Al > Cr, but for (TPP)M(PO)(+) the dissociation was M = Cr > Al. The single-crystal structural determinations on (R,R-salen)AlOCHMe(S)CH(2)Cl.0.5PO and (R,R-salen)AlO(2)CMe.1.5py grown in neat PO and pyridine, respectively, reveal five-coordinate aluminum(III) centers with the alkoxide/acetate ligands in the axial position of a square-based pyramid. These results are discussed in terms of the reactivity of these metal complexes in ring-opening polymerizations and copolymerizations with PO and CO(2), respectively.