Power generation from linear finger-tapping-based electrostatic energy harvesting (FTEEH) devices is hindered by the slow capacitance variation under low-speed finger-tapping (FT) motion. Herein, a velocity amplification mechanism is proposed, which exploits the snap-through behavior of a dual-charged electret monostable dome structure and thus greatly enhances the power generation of FTEEH devices from slow FT motion. The kinetic energy and velocity amplification during the buckling event were effectively predicted for various specimens using the modified Föppl–von Kármán equations and Hamilton's principle. A high degree of dynamic velocity amplification was demonstrated both theoretically and experimentally and quantified with respect to the velocity gain and power gain. Specifically, the velocity of the capacitance variation of the designed FTEEH device, driven by a slow FT motion at 2.7 cm/s, was substantially increased to 18.5 cm/s, affording a high velocity gain of 6.9 and a correspondingly large power gain of 6.8. The proposed velocity-amplified nonlinear FTEEH device was compared with recently developed linear FTEEH devices that do not utilize this velocity amplification mechanism and found to yield a large pulse width of 90.0 ms (full width) and a high volumetric power density of 1015.7 μW/cm3.
Hybrid vibration energy harvesting technology converts vibration energy into electricity using multiple transduction mechanisms to improve output power. A frequency‐tunable resonant hybrid vibration energy harvester using a piezoelectric cantilever with electret‐based electrostatic coupling is proposed in this article. The electrostatic coupling including electrostatic force coupling and electrical damping coupling is introduced by an electret film placed below the cantilever, where the electrostatic force acting on the cantilever realises a tunable resonant frequency and additional electrical damping boosts power output. A coupling electromechanical model is derived using Euler–Bernoulli beam theory and Kirchhoff's law. By investigating the static and dynamic stability of cantilever, the maximum electret surface potential is defined to prevent the pull‐in phenomenon. The damping of the device is evaluated, and the optimal electret surface potential is determined to obtain the matching of the electrical and mechanical damping for maximum power output. The resonant frequency of hybrid vibration energy harvester can be adjusted in range of 176.1 rad/s by changing the electret surface potential and resistive load. The experimental output power of hybrid vibration energy harvester was 5.2 μW, 27.4 times higher than that of the individual piezoelectric generator. The proposed hybrid vibration energy harvester exhibits a promising potential to power microelectronic devices and wireless sensor network node.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.