International audienceSolar thermal energy represents an increasingly attractive renewable source.However,to provide continuous availability of this energy,it must be stored. This paper presents the state of the art on high temperature(573-1273K)solar thermal energy storage based on chemical reactions,which seems to be the most advantageous one for long-term storage. The paper summarizes the numerical,experimental and technological studies done so far. Each system is described and the advantages and drawbacks of each reaction couple are considered

This paper analyses a thermochemical energy storage process using a CaO/Ca(OH) 2 chemical loop. A single circulating fluidized bed reactor is proposed to carry out the hydration-dehydration alternating reactions. During the energy discharge step, steam is fed to the reactor and used as a fluidizing gas and as a reactant with the CaO coming from a silo, enabling heat to be recovered at a sufficiently high temperature (around 743 K) from the hydration reaction taking place in the fluidized bed. During the dehydration of Ca(OH) 2 (energy charging step), heat (i.e. from a concentrated solar field) is stored in thermochemical form as CaO by using steam as a fluidizing gas. A basic process integration scheme for a reference case with a power output of 100 MW t is analysed in this work, by solving the mass and energy balances during charging and discharging steps and by calculating the volume of the silos and characteristic dimensions of the fluidized bed reactor. The effective energy storage densities of the CaO silo is shown to 2 be over 260 kWh/m 3 with reasonable activities of the solids when storing CaO solids in the silo at around 813 K.

International audienceThe use of heat exchanger/reactors (HEX/reactors) is a promising way to overcome the barrier of poor heat transfer in batch reactors. However to reach residence time long enough to complete the chemistry,low Reynolds number has to be combined with both a plug flow behaviour and the intensification of heat and mass transfers. This work concerns the experimental approach used to characterize an innovative HEX/reactor. The pilot is made of three process plates sandwiched between five utility plates. The process stream flows in a 2 mm corrugated channel. Pressure drop and residence time distribution characterizations aim at studying the flow hydrodynamics. Identified Darcy correlations point out the transition between laminar and turbulent flow around a Reynolds number equal to 200. Moreover the flow behaves like a quasi-plug flow (Pe > 185). The heat transfer and mixing time have also been investigated. The ratio between the reaction kinetics and the mixing time is over 100 and the intensification factor ranges from5000 to 8000 kW m−3K−1. As a consequence, no limitations were identified which allows the implementation of an exothermic reaction. It has been successfully performed under severe temperature and concentration conditions, batchwise unreachable. Thus, it highlights the interest of using this continuous HEX/reactor