Silver nanoparticles possess antibacterial effect for various bacteria; however mechanisms of the interaction between Ag-NPs and bacterial cells remain unclear. The aim of our study was to obtain direct evidence of Ag-NPs penetration into cells of Gram-negative bacterium S. typhimurium and Gram-positive bacterium S. aureus, and to study cell responses to Ag-NPs. The Ag-NPs (most 8-10 nm) were obtained by gas-jet method. S. typhimurium (7.81 × 10⁷ CFU), or S. aureus (8.96 × 10⁷ CFU) were treated by Ag-NPs (0.05 mg/l of silver) in orbital shaker at 190 rpm, 37 °C. Bacteria were sampled at 0.5, 1, 1.5, 2, 5 and 23 h of the incubation for transmission electron microscopy of ultrathin sections. The Ag-NPs adsorbed on outer membrane of S. typhimurium and cell wall of S. auereus; penetrated and accumulated in cells without aggregation and damaging of neighboring cytoplasm. In cells of S. aureus Ag-NPs bound with DNA fibers. Cell responses to Ag-NPs differed morphologically in S. typhimurium and S. aureus, and mainly were presented by damage of cell structures. The cytoplasm of S. aureus became amorphous, while S. typhimurium showed lumping and lysis of cytoplasm which led to formation of "empty" cells. Other difference was fast change of cell shape in S. typhimurium, and late deformation of S. aureus cells. The obtained results showed how different could be responses induced by the same NPs in relatively simple prokaryotic cells. Evidently, Ag-NPs directly interact with macromolecular structures of living cells and are exert an active influence on their metabolism.

No abstract

No abstract

The evaporation dynamics of a water droplet with an initial volume of 2 μl from glass surfaces with fluoropolymer coatings are investigated using the shadow technique and an optical microscope. The droplet profile for a contact angle of less than 5° is constructed using an image-analyzing interference technique, and evaporation dynamics are investigated at the final stage. We coated the glass slides with a thin film of a fluoropolymer by the hot-wire chemical vapor deposition method at different deposition modes depending on the deposition pressure and the temperature of the activating wire. The resulting surfaces have different structures affecting the wetting properties. Droplet evaporation from a constant contact radius mode in the early stage of evaporation was found followed by the mode where both contact angle and contact radius simultaneously vary in time (final stage) regardless of wettability of the coated surfaces. We found that depinning occurs at small contact angles of 2.2-4.7° for all samples, which are smaller than the measured receding contact angles. This is explained by imbibition of the liquid into the developed surface of the "soft" coating that leads to formation of thin droplets completely wetting the surface. The final stage, which is little discussed in the literature, is also recorded. We have singled out a substage where the contact line velocity is abruptly increasing for all coated and uncoated surfaces. The critical droplet height corresponding to the transition to this substage is about 2 μm with R/h = 107. The duration of this substage is the same for all coated and uncoated surfaces. Droplets observed at this substage for all the tested surfaces are axisymmetric. The specific evaporation rate clearly demonstrates an abrupt increase at the final substage of the droplet evaporation. The classical R law is justified for the complete wetting situation where the droplet is disappearing in an axisymmetric manner.