Background. The variety of polishing systems and tools available for finishing direct composite restorations may perplex the dentist.Objectives. An effect evaluation in one- and multi-step composite polishing tools using model specimens of GC Gradia Direct and 3M ESPE Filtek Ultimate restoratives.Methods. The prepared specimens of GC Gradia Direct and 3M ESPE Filtek Ultimate restorative composites were exposed in laboratory to the Kenda Maximus, Dentsply PoGo, Kagayaki RoundFlex, Shofu Super-Snap, Kagayaki Ensmart Pin, EVE Composoft polishing systems and Daiyamondo Kagayaki paste. The polishing systems distinguished by brand, technical and performance characters.Surface microgeometry in all 16 samples was estimated in the Laboratory of Optical Metrology, Institute of Design and Technology for Scientific Instrument Engineering, Novosibirsk, using a MNP-1 light interferometric nanoprofile microscope and at the shared core facilities of the Research and Education Centre “Nanomaterial Diagnostics and Properties” of Kuban State University, Krasnodar, using a JEOL JSM-7500F scanning electron microscope.Results. Optical profilometry and scanning electron microscopy were used to estimate surface roughness in 16 specimens exposed to polishing for one minute. The polishing tools Kenda Maximus, Dentsply PoGo, Kagayaki RoundFlex, Shofu Super-Snap, Kagayaki Ensmart Pin, EVE Composoft, as well as Daiyamondo Kagayaki paste used in instrumental polishing, revealed a varied performance. Optical profilometry exhibited the GC Gradia Direct and Filtek Ultimate specimens to possess the lowest average roughness in two cases: 1) after multi-step polishing with Kagayaki Ensmart Pin tools with Daiyamondo Kagayaki paste (average roughness corresponded to Sa — 0.214 pm in GC Gradia Direct and Sa — 0.248 pm — in Filtek Ultimate), 2) in application of the Kenda Maximus monopolishing tool (roughness values of Sa — 0.211 and Sa — 0.242 pm, respectively). Surface roughness after multi-step machining with EVE Composoft silicone polishers was average Sa — 0.579 and Sa — 0.549 pm in both samples and was reported the highest. Scanning electron microscopy confirmed the optical profilometry estimates.Conclusion. The assay showed that the specimen machining with a sole Kenda Maximus diamond abrasive tool and several Kagayaki Ensmart Pin silicone polishing heads followed by a Daiyamondo Kagayaki diamond abrasive paste application produced very similar surface roughness values, which were graded the lowest with GC Gradia Direct and 3M ESPE Filtek Ultimate composite samples using scanning electron microscopy and optical profilometry.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.