Comprehensive Materials Finishing 2017
DOI: 10.1016/b978-0-12-803581-8.09200-6
|View full text |Cite
|
Sign up to set email alerts
|

3.13 Finishing and Post-Treatment of Thermal Spray Coatings

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
3
1
1

Citation Types

0
7
0

Year Published

2019
2019
2024
2024

Publication Types

Select...
8
1

Relationship

0
9

Authors

Journals

citations
Cited by 11 publications
(7 citation statements)
references
References 65 publications
0
7
0
Order By: Relevance
“…To meet these mechanical elements and guarantee them pre-established dimensions, they must be subjected to a precision finishing operation. As a result, coatings are often turned, milled or ground [9].…”
Section: Ii1 Thermal Spraymentioning
confidence: 99%
See 1 more Smart Citation
“…To meet these mechanical elements and guarantee them pre-established dimensions, they must be subjected to a precision finishing operation. As a result, coatings are often turned, milled or ground [9].…”
Section: Ii1 Thermal Spraymentioning
confidence: 99%
“…According to [9], some care must be taken when milling thermally sprayed flat surfaces: priority should be given to removing raised areas or irregularities and making very light cuts; in crosscut tangential milling, care must be taken to avoid lifting the coating from the substrate; cutting speeds should be in the range of 20 to 30 m/min, however, they can be higher when milling some materials, such as copper alloys; the feed is usually 0.2 -0.5 mm/revolution for roughing and should be reduced according to the finishing required.…”
Section: Ii2 Milling Thermal Sprayed Materialsmentioning
confidence: 99%
“…Advantages Improves resistance to fatigue [166] Disadvantages It is not suitable for small surface area [167] 5.1.6. Electrophoretic Deposition Electrophoretic deposition is a method that uses an electric field to move colloidal particles suspended in the electrolyte in order to be deposited onto the substrate.…”
Section: Advantages/disadvantages Referencesmentioning
confidence: 99%
“…Nevertheless, this treatment is limited in application to rather small sized pieces and is relatively expensive [154]. The HIP treatment is used mainly for ceramic and cermet coatings [155,156] and less for alloy ones [157][158][159].…”
Section: Combined Treatmentmentioning
confidence: 99%