Untitled

Bessmertnyi, V. S.; Krokhin, V. P.; Panasenko, V. A.; Drizhd, N. A.; Dyumina, P. S.; Kolchina, O. M.

doi:10.1023/a:1012395116066

Search citation statements

Order By: Relevance

Paper Sections

Select...

Results1

Introduction1

Citation Types

Supporting

Mentioning

Contrasting

Year Published

2005

2021

Publication Types

Select...

Article7

Relationship

Self Cite0

Independent7

Authors

Journals

Cited by 13 publications

(2 citation statements)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…According to the temperature interval of 370 o C for glass viscosity 10 2 -10 8 Pa•s this glass belongs to long therm glasses, Fig. 5 [24].…”

Section: Resultsmentioning

confidence: 99%

The thermophysical properties of primary phase in lithium germanium phosphate glass

et al. 2021

View full text Add to dashboard Cite

The selected lithium germanium-phosphate glass was prepared by a conventional melt-quenching technique. The XRD method was employed to confirm the glass was obtained and to reveal crystalline phases during heat treatment. The dilatometry (DIL), differential thermal analysis (DTA), and differential scanning calorimetry (DSC) were used to determine the characteristic temperatures and enthalpies of crystallization and melting of the crystalline phase. The DTA and DIL were used to obtain the viscosity curves by applying the Vogel-Fulcher-Tammann (VFT) equation

show abstract

“…According to the temperature interval of 370 o C for glass viscosity 10 2 -10 8 Pa•s this glass belongs to long therm glasses, Fig. 5 [24].…”

Section: Resultsmentioning

confidence: 99%

The thermophysical properties of primary phase in lithium germanium phosphate glass

et al. 2021

View full text Add to dashboard Cite

show abstract

“…Because of the high temperature in the plasma, this technique is particularly fit for spraying ceramics. However, it has never been tested with glasses, except for few studies [5,6], in particular in the biomaterials research field [7]. Powders of high performance glasses and glass-ceramics are difficult to sinter, when employed as glazes on traditional ceramics, because they require higher firing temperatures than the ceramic bodies and/or the addition of low-melting point compounds, which lower sintering temperature but also reduce mechanical and chemical properties.…”

Section: Introductionmentioning

confidence: 99%