A design of high voltage pre-regulator circuit for LED driver

Tang, Junlong; Dai, Chaoxiong; Ouyang, Luoluo; Wang, Yaodong; Zou, Wanghui

doi:10.1109/isne48910.2021.9493636

Cited by 5 publications

(1 citation statement)

References 7 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Bias generation circuit generates proper bias voltage and current for LDO[14,15]. The error amplifier detects the change of the output voltage through the feedback resistors R1 and R2, compares Vfb with the reference voltage Vref, then controls the gate voltage of the power transistor M0 to stabilize the output voltage[16,17,18,19,20]. In particular, this design presents a transient enhancement loop that provides an additional fast control loop for the gate of M0 and acts as an active capacitor to provide transient charge and discharge currents at the output point, enhancing transient response without the off-chip capacitors…”

mentioning

confidence: 99%

A wide input range, external capacitor-less LDO with fast transient response

Gao

Cai

Yan

et al. 2023

IEICE Electron. Express

View full text Add to dashboard Cite

A high voltage, external capacitor-less low-dropout regulator (HVLDO) with transient enhancement loop is presented in this work. The proposed HVLDO is designed with high withstand voltage laterallydiffused MOS (LDMOS) transistors and a transient enhancement loop is proposed to properly inject/sink current to/from the gate and output nodes of the power transistors to achieve fast transient response and high stability. Fabricated in 0.5 μm SOI BCD process, the HVLDO occupies an active area of 0.29 mm 2 . Operating with an input voltage ranging from 5.2 to 20 V, it supplies an output voltage of 5 V and a maximum load of 100 mA. For all load conditions, this design has the power supply rejection of -49 dB@ 100 kHz, the phase margin over 68.4 deg and achieves a temperature coefficient of 13.15 ppm/°C. Measurement results show that this design has a line regulation of 0.88 mV/V and a load regulation of 0.22 mV/mA. The proposed HVLDO features fast line transient response of 60/20 mV@ 9.8 V/µs, fast load transient response of 30/70 mV@100 mA/µs, and recovery time of 2 µs without external capacitors. Compared with the prior art, this work achieves the best transient FOM of 12.19 fs.

show abstract