A new nonlevitated mode of traveling wave toner transport

Schmidlin, F. W.

doi:10.1109/28.81831

Cited by 44 publications

(19 citation statements)

References 4 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…3a). Many investigations have since been conducted on development of the electric curtain technology mainly as a toner supplier in electrophotography (Melcher et al 1989a and1989b;Schmidlin 1991Schmidlin , 1995Schmidlin and 1999Thompson et al 1999;Moesner 1999;Kober 2000 andTaniguchi et al 2000 andKawamoto et al 2004 and2006).…”

Section: Electrostatic/electrodynamic Methodsmentioning

confidence: 98%

Review of dust transport and mitigation technologies in lunar and Martian atmospheres

Afshar-Mohajer

Curtis

et al. 2015

Advances in Space Research

View full text Add to dashboard Cite

Section: Electrostatic/electrodynamic Methodsmentioning

confidence: 98%

Review of dust transport and mitigation technologies in lunar and Martian atmospheres

Afshar-Mohajer

Curtis

et al. 2015

Advances in Space Research

View full text Add to dashboard Cite

“…The main concern, though, is the propensity of the tribo charging mechanism to yi either positive or negative charge. To mi of "wrong" sign toner on the image chosen to implement the electro sta traveling wave (TW) grid [3,4] We have implemented and tested grids by laser-drilling holes in multila with alternating dielectric and cond Figure 11 shows a 10 by 10 array of ver that are laser drilled through a stack Kapton sheets. The aperture holes are 5 and allow continuous transport wi blocking (500 V pulses at 10 Hz).…”

Section: Gatingmentioning

confidence: 99%

Ballistic aerosol marking

Völkel

Anderson

Endicott

et al. 2013

2013 Transducers &Amp; Eurosensors XXVII: The 17th International Conference on Solid-State Sensors, Actuators and Microsystems

View full text Add to dashboard Cite

Ballistic Aerosol Marking (BAM) printing concept that combines the sim marking technique such as inkjet printin and color range/stability of Xerography by using high-speed gas jets as the tr Xerographic toner particles as the markin In this paper we will provide an intr novel concept, discuss design con Computational Fluid Dynamics (CFD) simulations, and show some proof-of-co single channel experiments.

show abstract

“…Various studies have investigated the electric curtain experimentally [3,[8][9][10][11][12][13][14][15][16][17] and with numerical modeling of individual particles' trajectories [4,6,7,[18][19][20][21][22]. The traditional premise of the electric curtain is the manipulation of charged particles via Coulombic forces; it is typically assumed that these particles are either inherently charged or they obtain a net charge from absorption of gaseous ions from corona [3].…”

Section: Introductionmentioning

confidence: 99%

Particle-Induced Electrostatic Repulsion within an Electric Curtain Operating below the Paschen Limit

et al. 2022

View full text Add to dashboard Cite

The electric curtain is a platform developed to lift and transport charged particles in air. Its premise is the manipulation of charged particles; however, fewer investigations isolate dielectric forces that are observed at lower voltages (i.e., less than the Paschen limit). This work focuses on observations of simultaneous dielectrophoretic and electrostatic forces. The electric curtain was a printed circuit board with interdigitated electrodes (0.020 inch width and spacing) coated with a layer of polypropylene, where a standing wave or travelling wave AC signal was applied (50 Hz) to produce an electric field below the Paschen limit. Soda lime glass beads (180–212 µm) demonstrated oscillatory rolling via dielectrophoretic forces. In addition, several particles simultaneously experienced rapid projectile repulsion, a behavior consistent with electrostatic phenomena. This second result is discussed as a particle-induced local increase in the electric field, with simulations demonstrating that a particle in close proximity to the curtain’s surface produces a local field enhancement of over 2.5 times. The significance of this is that individual particles themselves can trigger electrostatic repulsion in an otherwise dielectric system. These results could be used for advanced applications where particles themselves provided triggered responses, perhaps for selective sorting of micrometer particles in air.

show abstract

A new nonlevitated mode of traveling wave toner transport

Cited by 44 publications

References 4 publications

Review of dust transport and mitigation technologies in lunar and Martian atmospheres

Review of dust transport and mitigation technologies in lunar and Martian atmospheres

Ballistic aerosol marking

Particle-Induced Electrostatic Repulsion within an Electric Curtain Operating below the Paschen Limit

Contact Info

Product

Resources

About