A New Photovoltaic Energy Sharing System between Homes in Standalone Areas

Abstract

Today, global energy consumption is dominated by fossil fuels such as oil, coal and gas. The intensive consumption of these energy sources gives rise to greenhouse gas emissions and therefore an increase in CO2 emissions. Photovoltaic energy has persistently been considered as a green and pollution-free renewable energy source to overcome greenhouse effect and energy crisis. This paper describes a new method of photovoltaic energy sharing in standalone micro-grids using photovoltaic panels. This approach is based on automatic electrical energy sharing depending on the state of charge (SOC) of the electrical storage unit using by each home and on the electrical power consumption of each home.The monitoring system is connected to each home in micro-grid, it manage each home’s energy use, and assigns more energy to a large energy-consuming home. This architecture contributes to reducing total energy lost.

Study of PLTMH development planning in sasnek village sawiat district, South Sorong Regency West Papua Province

“…At PLTMH Sasnek rotation of the turbine shaft from the calculation of the flow of water is 2 liters/sec, while the rotation needed a generator to produce electrical power is 1500 rpm then by way increases the flow rate of discharge and the volume of water required body mounting container reserves by raising capacity his shelter. PLTMH Sasnek shaped mechanical transmission pulley with appropriate diameter ratio associated with V-Belt [35][36][37][38].…”

A practical method to design the solar photovoltaic system applied on residential building in Indonesia

“…This technology uses silicon wafers to convert sunlight energy into electrical energy [1]- [4]. The use of solar power generation systems has been very diverse, such as centralized generators, distributed generators, solar home systems [5]- [7], solar water pumping systems [8]- [10], public street lighting [11]- [15] and also in the operation of electric vehicles [16]. Many of these systems have also been utilized to reduce the consumption of electrical energy from public networks with a smart-grid topology.…”

A comparison of single phase standalone square waveform solar inverter topologies: half bridge and full bridge

“…With the revolution and the advance of the use of photovoltaic installations all around the word, many designs and conceptions of photovoltaic devices have been developed [1][2][3], especially the conception and the design of DC-DC and DC-AC converters circuits [4][5][6]. Because of the low efficiency and the high cost of solar modules in photovoltaic systems [7], the effiecicy and the cicuits simplicity of the other devices of photovoltaic system have to be the most higher possible.…”