“…Also, note that the fine details of heat release mechanisms and their physics in these different combustion modes may influence the characteristics of p , but (1.1) clearly notes that the integral value drives the pressure fluctuation and thus the direct noise only depends on the combustion mode through its influence on the rate of change of the total rate of heat released, as noted by Price et al (1968) and Strahle (1971). However, the following points can be noted from a number of studies on combustion noise emitted by premixed Strahle 1978;Strahle & Shivashankara 1975;Kilham & Kirmani 1979;Kotake & Takamoto 1987Rajaram & Lieuwen 2003;Hirsch et al 2007), non-premixed (Ohiwa, Tanaka & Yamaguchi 1993;Klein & Kok 1999;Singh, Frankel & Gore 2004;Flemming, Sadiki & Janicka 2007;Ihme, Pitsch & Bodony 2009) and partially premixed (Singh et al 2005;Duchaine, Zimmer & Schuller 2009) flames: (i) the combustion noise has a broadband spectrum with a peak sound level of about 60-80 dB in the frequency range of about 200-1000 Hz, (ii) the overall SPL increases with the fuel flow rate and the heating value of the fuel, (iii) there is a considerable increase in the SPL if one mixes air with the fuel (Singh et al 2005) so that the equivalence ratio stays beyond the rich flammability limit; however, this observed increase might be due to room resonance since the experiment was not carried out in an anechoic environment. Even in liquid-fuel spray combustion , the acoustic source may be represented by a collection of monopoles as suggested by (1.1).…”