A Study of Fluid Bed Granulation of Pravastatin Tablet Using Design of Experiments

Abstract

Objective: The objective of this study was to reduce size and weight of pravastatin tablet through quality by design approach; potential factors (spray rate, atomizing pressure, and inlet temperature) which could influence on the production process for critical process parameters of wet granulation using fluid-bed granulator were examined.Methods: The manufacturing process of the reduced weight and size formulation pravastatin tablet involves wet granulation, drying, granulate screening, blending, and tableting. Design of experiments study for wet granulation of the reduced weight/size pravastatin tablet was produced on 11 combinations of three factors (spray rate, atomizing pressure, and inlet temperature), which were chosen through initial risk assessment. The process of wet granulation was rated by measuring four responses: loss on drying (LOD) (%), bulk density (g/ml), product temperature (°C), and dissolution similarity (f2).Results: It was measured that LOD varied from 1.46 to 3.24%, bulk density from 0.34 to 0.51 g/ml, product temperature from 40.12 to 51.69°C, and dissolution (f2) of pravastatin from 52.14 to 58.91. Control strategy for wet granulation production of the reduced weight and size pravastatin tablet by our results demonstrated that the most optimized condition of three factors for wet granulation is spray rate (3–5 g/min), atomizing pressure (about 1 bar), and inlet temperature (65–90°C), respectively. Updated risk assessment and justification by all experimental data safely existed within the range of acceptance criteria were presented.Conclusion: It can be concluded that the ideal ranges of three factors (spray rate, atomizing pressure, and inlet temperature) in wet granulation were successfully identified.

Evaluation of Mechanical Strength After Compression of Metformin 500mg Tablets Produced by Different Wet Routes

“…Among the various technologies applied for the production of granules by the wet method, the fluidized bed is one of the most advantageous, since the mixing, granulation, and drying steps can be performed in a single equipment, continuously [7][8][9][10]. In this procedure, the powder particles are suspended by a rising air stream, receiving a jet of the agglutinating solution.…”