An analysis on the optimal fields number of the plate-type electrostatic precipitators used in a thermoelectric power plant

Popa, Gabriel Nicolae; Vaida, Victor; Deaconu, Sorin Ioan; Sora, Ioan

doi:10.1109/optim.2010.5510471

Cited by 6 publications

(8 citation statements)

References 7 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The power plant has six power sections (210 MW) each connected to a boiler and it has twelve ESPs (with three and four sections). The main geometrical data of precipitators used at the thermal power station are given in Table 1 [11].…”

Section: Simulated Results Of Average Migration Velocitymentioning

confidence: 99%

“…The discharge wires have negative polarity and the collecting plates are grounded. The firing angle of the thyristor is determined by an automatic voltage controller for every half-cycle of the low-voltage [11].…”

Section: Classical Energization Types For Esp Sectionsmentioning

confidence: 99%

“…The characteristics of bituminous coal used in the thermo electric power plant (S.C. Electrocentrale Deva S.A., Romania) is presented in Table 5 [11]. This thermal power station has ESPs with three or four sections that treat large gas flows.…”

Section: Technological Measurements Upon Some Parametersmentioning

confidence: 99%

See 2 more Smart Citations

An analysis on the velocity of dust particles in the plate-type electrostatic precipitators used in thermoelectric power plants

Popa

Sora²,

Diniş³

et al. 2014

Environ. Protect. Eng.

View full text Add to dashboard Cite

Experimental data collected from different plate-type electrostatic precipitators used in a thermoelectric power plant has been analyzed. The following parameters were considered: the collection efficiency, average migration velocity of dust particles, velocity distribution of the gas in the input and output channels of precipitators. The average migration velocity of dust particles can be estimated using various mathematical models, and the gas velocity can be computed using the velocity distributions from the input channels of the precipitators. The traveling time of dust particles between the electrodes is smaller than the traveling time along the precipitator sections.

show abstract

Section: Simulated Results Of Average Migration Velocitymentioning

confidence: 99%

Section: Classical Energization Types For Esp Sectionsmentioning

confidence: 99%

See 1 more Smart Citation

An analysis on the velocity of dust particles in the plate-type electrostatic precipitators used in thermoelectric power plants

Popa

Sora²,

Diniş³

et al. 2014

Environ. Protect. Eng.

View full text Add to dashboard Cite

show abstract

“…14). The filter characteristics depends on impedance of the source (Z s ) and the impedance of the filters (Z F ) [12], [13].…”

Section: Simulations Of a Classical DC Energization For Esp Sections With Passive Filtermentioning

confidence: 99%

“…The power sources that supply the ESP sections, depending on the constructive solution, the operational diagram and the voltage's adjusting regime determine and increased safety and efficiency for collecting the dust from the gas result further different industrial processes [11]- [13].…”

Section: Introductionmentioning

confidence: 99%

Considerations on the Current Harmonics of Plate-Type Electrostatic Precipitators Power Supplies

Popa

Diniş

Deaconu

2013

ElAEE

View full text Add to dashboard Cite

Plate-type electrostatic precipitators are the main installations of separating particles from industries (especially for large gas flow) and must operate in its electromagnetic environment without interfering with the operation of other equipments. The power supplies have non-linear elements that cause distortions of the sources currents. The main objective of this work is to analyze measure and simulate currents, voltages and powers from the sources that are used (thyristor-controlled reactor type) taking into account a new electric model, more close to reality, of the ESP sections. It's analyzed the modification of the current waves shape and THD in case of using passive filters.

show abstract

Modelling of some parameters from thermoelectric power plants

Popa

Diniş

Deaconu

et al. 2016

IOP Conf. Ser.: Mater. Sci. Eng.

View full text Add to dashboard Cite

An analysis on the optimal fields number of the plate-type electrostatic precipitators used in a thermoelectric power plant

Cited by 6 publications

References 7 publications

An analysis on the velocity of dust particles in the plate-type electrostatic precipitators used in thermoelectric power plants

An analysis on the velocity of dust particles in the plate-type electrostatic precipitators used in thermoelectric power plants

Considerations on the Current Harmonics of Plate-Type Electrostatic Precipitators Power Supplies

Modelling of some parameters from thermoelectric power plants

Contact Info

Product

Resources

About