An analytic model for the response of a CZT detector in diagnostic energy dispersive x‐ray spectroscopy

Abstract

A CdZnTe detector (CZTD) can be very useful for measuring diagnostic x-ray spectra. The semiconductor detector does, however, exhibit poor hole transport properties and fluorescence generation upon atomic de-excitations. This article describes an analytic model to characterize these two phenomena that occur when a CZTD is exposed to diagnostic x rays. The analytical detector response functions compare well with those obtained via Monte Carlo calculations. The response functions were applied to 50, 80, and 110 kV x-ray spectra. Two 50 kV spectra were measured; one with no filtration and the other with 1.35 mm Al filtration. The unfiltered spectrum was numerically filtered with 1.35 mm of Al in order to see whether the recovered spectrum resembled the filtered spectrum actually measured. A deviation curve was obtained by subtracting one curve from the other on an energy bin by bin basis. The deviation pattern fluctuated around the zero line when corrections were applied to both spectra. Significant deviations from zero towards the lower energies were observed when the uncorrected spectra were used. Beside visual observations, the exposure obtained using the numerically attenuated unfiltered beam was compared to the exposure calculated with the actual filtered beam. The percent differences were 0.8% when corrections were applied and 25% for no corrections. The model can be used to correct diagnostic x-ray spectra measured with a CdZnTe detector.

Design of a digital phantom population for myocardial perfusion SPECT imaging research

“…The model of CZT energy spectral includes three parts: the charge induction efficiency as a function of depth of interaction, the probability that a gamma photon deposit its energy as a function of depth, and a Gaussian distribution of the generated charge carriers (LeClair et al , 2006). …”

Least squares parameter estimation methods for material decomposition with energy discriminating detectors

“…The spectrum can further be distorted by florescent photons that are generated during the de-excitation of an atom following a photoelectric event. 42 The florescent photons can also propagate through the crystal and interact with other atoms of the detector. These processes can be simulated and they are the subject of ongoing investigations.…”

“…Another deteriorating factor is the hole tailing phenomenon. 42 As electrons and holes are created in the crystal, they drift in the opposite direction toward the corresponding electrodes. The ability of these charge carriers to move depends on their mobility lifetime product and the material properties of the CZT crystal.…”

A method to estimate the fractional fat volume within a ROI of a breast biopsy for WAXS applications: Animal tissue evaluation

“…The effects caused by the CdTe detector response will need to be assessed for the higher kV analysis. 39 Since the scatter signals from the amorphous samples are circularly symmetric, a detector matrix of CZT pixels 40 would allow a larger portion of the scattered field to be captured thereby reducing the uncertainty. However, at this time, such a detector is not available to the research program.…”