An Analytical Framework of Multisector Rectenna Array Design for Angular Misalignment Tolerant RF Power Transfer Systems

Kumar, Manoj; Kumar, Sundeep; Sharma, Ashwani

doi:10.1109/tmtt.2022.3222195

Cited by 14 publications

(5 citation statements)

References 46 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Where 𝜂 𝑅𝐹−𝐷𝐶 is the efficiency, 𝑃 𝐷𝐶 is the power produced at the load, and 𝑃 𝑅𝐹 is the power received at the receiving microstrip antenna. The 𝑃 𝑅𝐹 is computed from the equation of Friis transmission as in (5) where 𝜆 is the operating wavelength 𝑟 is the distance between the transmitting part and receiving antenna, 𝑃 𝑇 is the transmitted power of the transmitting antenna, 𝐺 𝑇 and 𝐺 𝑅 are the gain of the transmitting antenna and the receiving antenna respectively.…”

Section: Proposed Microstrip Rectifier Circuit Designmentioning

confidence: 99%

“…WPT is effective in areas where wires and batteries are inaccessible, and it is a strategy that serves to produce electricity in a non-polluting way and leads to preserving the primary resources of fossil and nuclear power plants. WPT system is decomposed into a transmission part and a reception part called the rectenna system [4], [5]. The first part involves converting the direct current (DC) to microwave power.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Improved design and performance of the global rectenna system for wireless power transmission applications around 2.45 GHz

En-Naghma,

Halaq,

El Ougli

2024

IJECE

View full text Add to dashboard Cite

This work proposes a new conception of the global microstrip rectenna system operating around 2.45 GHz. This improved rectenna system associates a receiving antenna with a rectifier circuit. This rectenna is printed on an FR4 substrate. The proposed antenna is a 1×4 microstrip antenna patch array with pentagonal patches using the defective ground structure method and operates with circular polarization. To show the effectiveness of this array, the results obtained by the computer simulation technology microwave studio (CST MWS) software prove that this array is good in terms of high gain, high directivity, high efficiency, wideband, small volume, and well-adaptation, and all these results are confirmed by another solver high-frequency structure simulator (HFSS). The improved rectifier is a microstrip rectifier that uses an HSMS2852 Schottky diode by using a series topology. The effectiveness of this rectifier is proved by the simulation results using advanced design system (ADS) software in terms of well-matching input impedance, high efficiency, and important output direct current (DC) voltage value. The proposed rectenna system is more efficient compared with the existing works and is very appropriate for several applications of wireless power transmission to power supply electronic instruments in various fields cleanly on our planet.

show abstract

Section: Proposed Microstrip Rectifier Circuit Designmentioning

confidence: 99%

Section: Introductionmentioning

confidence: 99%

Improved design and performance of the global rectenna system for wireless power transmission applications around 2.45 GHz

En-Naghma,

Halaq,

El Ougli

2024

IJECE

View full text Add to dashboard Cite

show abstract

“…So far, many efforts have been made to increase the power conversion efficiency (PCE) and reduce the cost of rectennas used for the long-range (far-field) wireless energy harvesting and power transmission [14][15][16][17][18][19][20][21]. The simplest possible rectenna configuration could be to exploit a compact omnidirectional antenna loaded with nonlinear electronic devices (e.g., diodes) [22][23][24][25][26][27][28][29][30][31][32], to directly rectify the ambient electromagnetic wave into the usable DC electricity.…”

Section: Introductionmentioning

confidence: 99%

A Low-Profile, Wide-Angle, and Bandwidth- Enhanced Rectenna for Radiative Energy Harvesting in the 12 GHz Band

Ha,

Nie,

Bağcı

et al. 2024

Antennas Wirel. Propag. Lett.

View full text Add to dashboard Cite

This letter proposes a low-profile rectenna with high gain and wide angular coverage for radio frequency (RF) energy harvesting and wireless power transmission applications. Specifically, a compact traveling-wave antenna (TWA) array with spatially multiplexed radiation patterns is integrated with a miniature rectifying circuit and a DC power combiner, enabling wide angular coverage and stable DC output power. Our numerical and experimental results show that the proposed rectenna can be robust against changes in the received power and the incident angle (from -65 o to 65 o , while allowing a wideband operation from 11.5 GHz to 12.5 GHz. The proposed rectenna exhibits a nearly constant DC output voltage of 1.8 V and a RF-to-DC power conversion efficiency of 45% at a power density of 2.86 mW/cm 2 over a wide range of incident angles and operating frequencies.

show abstract

“…The high motivation in WPT over the last few decades is due to these many advantages: the transmission of electrical energy to loads without wired connections, that ensures the autonomy of the mains socket [5], the elimination and reduction of interconnected cables and wires in order to avoid short circuits, and the reduction of the wireless devices weight by eliminating batteries that have a significant weight. In recent years, researchers have become increasingly interested in microwave power transmission (MPT) systems such as rectenna systems [6], [7]. The rectenna systems consist of two parts: the emitting part and the receiving part.…”

Section: Introductionmentioning

confidence: 99%

New conception of 3×4 circularly polarized antenna patch network for RF energy harvesting at 2.45 GHz

En-Naghma,

Halaq,

El Ougli

2023

IJEECS

View full text Add to dashboard Cite

This paper presents a developed design of a 3×4 circular polarization microstrip antenna patch array whose its resonance frequency is 2.45 GHz in the ISM band. This array is printed on a FR4 substrate of 1.58 mm thickness with a dielectric permittivity of 4.4. The basic antenna patch is a square shape inserted by a rectangular slot inclined positioned diagonally at the center to achieve circular polarization. In addition, a triangular-shaped slit is added at each of the four corners of the patch. The antenna array performance is tested numerically using two different software packages, CST MWS and HFSS. The antenna’s array size is compacted to a 22.7 cm×13.5 cm. The simulated results give good performance results in terms of return loss and gain; directivity is found to be 9.66 dBi at 2.45 GHz; the axial ratio value is 1.69 dB; and total efficiency is about 95.55% at 2.45 GHz. Then, the simulated results obtained by these two programs are in good agreement, which makes this proposed array design very suitable for radio frequency energy harvesting and its various applications to power supply different devices in a clean way for our environment.

show abstract

An Analytical Framework of Multisector Rectenna Array Design for Angular Misalignment Tolerant RF Power Transfer Systems

Cited by 14 publications

References 46 publications

Improved design and performance of the global rectenna system for wireless power transmission applications around 2.45 GHz

Improved design and performance of the global rectenna system for wireless power transmission applications around 2.45 GHz

A Low-Profile, Wide-Angle, and Bandwidth- Enhanced Rectenna for Radiative Energy Harvesting in the 12 GHz Band

New conception of 3×4 circularly polarized antenna patch network for RF energy harvesting at 2.45 GHz

Contact Info

Product

Resources

About