Analytical determination of load resistance value for MQ-series gas sensors: MQ-6 as case study

Abstract

The MQ-series gas sensors are attractive candidates in the area of gas concentration sensing due to their high sensitivity and low cost. Even though the sensor circuit sensitivity and sensor power dissipation level both depend on load resistance, the process of the load resistance selection has not been well researched, hence the need for this study. The derivation of model equations for determining the sensor circuit sensitivity and sensor power dissipation is presented. The derived equations were used to investigate a typical scenario of MQ-6 gas sensor under the influence of liquified petroleum gas (LPG). The variation of sensitivity with load resistance and that of power dissipation with sensor resistance were parametrically investigated. The load resistance that yields maximum sensor circuit sensitivity with the maximum sensor power dissipation less than the set threshold is the candidate resistance for the sensor circuit. The 20 kΩ load resistance recommended for MQ-6 in the datasheet was authenticated in this study, yielding the maximum possible sensor circuit sensitivity and tolerable sensor power dissipation of 0.195 mV/ppm and 3.125 × 10 −4 W, respectively.

Design of Water Quality Monitoring System for Koi Fish Farming Using NodeMCU ESP32 and Blynk Application Based on Internet of Things

“…The operating principle of this sensor is based on its resistance variation when in contact with the gas to be sensed. The magnitude of the sensor's output signal depends on the gas concentration, its nature, and the type of metal oxide used for the sensor surface [12].…”