The effect of pH, ionic strength (NaCl added), agitation speed, adsorbent mass, and contact time on the removal of tartrazine from an aqueous solution, using an organobentonite, has been studied. A complete factorial design 32 with two replicates was used to evaluate the influence of the dye concentration (30, 40, and 50 mg/L) and amount of adsorbent (25, 35, and 45 mg) on decolorization of the solution. Experimental data were evaluated with Design Expert® software using a response surface methodology (RSM) in order to obtain the interaction between the processed variables and the response. pH values between 2 and 9, stirring speed above 200 rpm, and contact time of 60 min did not have a significant effect on decolorization. The optimum conditions for maximum removal of tartrazine from an aqueous solution of 30 mg/L were follows: pH = 6.0, NaCl concentration = 0.1 M, stirring speed = 230 rpm, temperature = 20°C, contact time = 60 min, and the organobentonite amount = 38.04 mg. The equilibrium isotherm at 20°C was analyzed by means of the Langmuir and Freundlich models, and the maximum adsorption capacity obtained was 40.79 ± 0.71 mg/g. This adsorption process was applied in a sample of industrial wastewater containing tartrazine and sunset yellow, having obtained a decolorization rate higher than 98% for both dyes. These results suggest that organobentonite is an effective adsorbent for the removal of anionic dyes from an aqueous solution.