Automated electrotransformation of Escherichia coli on a digital microfluidic platform using bioactivated magnetic beads

Abstract

This paper reports on the use of a digital microfluidic platform to perform multiplex automated genetic engineering (MAGE) cycles on droplets containing Escherichia coli cells. Bioactivated magnetic beads were employed for cell binding, washing, and media exchange in the preparation of electrocompetent cells in the electrowetting-on-dieletric (EWoD) platform. On-cartridge electroporation was used to deliver oligonucleotides into the cells. In addition to the optimization of a magnetic bead-based benchtop protocol for generating and transforming electrocompetent E. coli cells, we report on the implementation of this protocol in a fully automated digital microfluidic platform. Bead-based media exchange and electroporation pulse conditions were optimized on benchtop for transformation frequency to provide initial parameters for microfluidic device trials. Benchtop experiments comparing electrotransformation of free and beadbound cells are presented. Our results suggest that dielectric shielding intrinsic to bead-bound cells significantly reduces electroporation field exposure efficiency. However, high transformation frequency can be maintained in the presence of magnetic beads through the application of more intense electroporation pulses. As a proof of concept, MAGE cycles were successfully performed on a commercial EWoD cartridge using variations of the optimal magnetic bead-based preparation procedure and pulse conditions determined by the benchtop results. Transformation frequencies up to 22% were achieved on benchtop; this frequency was matched within 1% (21%) by MAGE cycles on the microfluidic device. However, typical frequencies on the device remain lower, averaging 9% with a standard deviation of 9%. The presented results demonstrate the potential of digital microfluidics to perform complex and automated genetic engineering protocols. Published by AIP Publishing. [http://dx

OpenDrop: An Integrated Do-It-Yourself Platform for Personal Use of Biochips

“…Synthetic biology : Using OpenDrop to transform bacteria cells. Recently, researchers have proven that E. coli can be transformed on an electromicrofluidic platform by using magnetic beads [ 54 ]. We are aware of several research laboratories that are pushing the boundaries further as in trying to adapt the existing DIY kits for CRISPR/CAS9.…”

Scalable and Automated CRISPR-Based Strain Engineering Using Droplet Microfluidics

“…Multiplexed electroporation, however, is difficult to perform on-chip for multiple reasons, including cross contamination, and electrical wiring and footprint limitations. Previous efforts for multiplexing have relied on serial single-plex electroporation, such as flow-through devices with a single electroporation site 10,17,18 , or the number of parallel reactions is limited to less than 10 due to physical constraints of the device configuration and electrical systems 8,19,20 . These are slow, inefficient and low-throughput processes.…”

Droplet microfluidics for synthetic biology

“…54 Alternatively, Moore and colleagues modified the Illumina digital microfluidic system with similar electroporation electrodes to enable multiple multiplex automation genetic engineering (MAGE) cycles to deliver DNA into E. coli cells. 55 In addition to droplet transport and mixing by DMF, magnetic beads were bound to the E. coli cells to allow the several washing steps and media transfers required for MAGE. Another technique directly interfaced pin headers with a microfluidic chamber to improve the controllability of and ease of electroporation.…”