Abstract. Molecular hydrogen (H 2 ), its isotopic signature (deuterium/hydrogen, δD), carbon monoxide (CO), and other compounds were studied in the exhaust of a passenger car engine fuelled with gasoline or methane and run under variable air-fuel ratios and operating modes. H 2 and CO concentrations were largely reduced downstream of the three-way catalytic converter (TWC) compared to levels upstream, and showed a strong dependence on the air-fuel ratio (expressed as lambda, λ). The isotopic composition of H 2 ranged from δD=−140‰ to δD = −195‰ upstream of the TWC but these values decreased to −270‰ to −370‰ after passing through the TWC. Post-TWC δD values for the fuelrich range showed a strong dependence on TWC temperature with more negative δD for lower temperatures. These effects are attributed to a rapid temperature-dependent H-D isotope equilibration between H 2 and water (H 2 O). In addition, post TWC δD in H 2 showed a strong dependence on the fraction of removed H 2 , suggesting isotopic enrichment during catalytic removal of H 2 with enrichment factors (ε) ranging from −39.8‰ to −15.5‰ depending on the operating mode. Our results imply that there may be considerable variability in real-world δD emissions from vehicle exhaust, which may mainly depend on TWC technology and exhaust temperature regime. This variability is suggestive of a δD from traffic that varies over time, by season, and by geographical location. An earlier-derived integrated pure (end-member) δD from anthropogenic activities of −270‰ (Rahn et al., 2002) Correspondence to: M. K. Vollmer (martin.vollmer@empa.ch) can be explained as a mixture of mainly vehicle emissions from cold starts and fully functional TWCs, but enhanced δD values by >50‰ are likely for regions where TWC technology is not fully implemented. Our results also suggest that a full hydrogen isotope analysis on fuel and exhaust gas may greatly aid at understanding process-level reactions in the exhaust gas, in particular in the TWC.