Chemical Solution Deposition of Protective Er₂O₃ and Y₂O₃ Coatings onto Stainless Steel for Molten Metal Casting using Metal-Nitrate Precursors

Abstract

Chemical solution deposition (CSD) methods involving the thermal decomposition of 5.0 M Er(NO 3 ) 3 •5H 2 O and Y(NO 3 ) 3 •6H 2 O precursor solutions were employed to fabricate protective erbia and yttria coatings onto stainless steel (SS304/SS316) coupons. The two techniques tested were dip and spray coating, which were then compared to a commercial yttria spray (ZYP Coatings). It was determined that solution concentration, solvent choice, injection of Er 2 O 3 and Y 2 O 3 micropowder, and the annealing temperature/ramp profile were critical to the coatings' physical properties. For dip coatings, thicknesses were 1−20 μm after two dipping/annealing cycles, and adhesion strength was ∼1000 psi, increasing up to ∼1300 psi if the SS coupons had preliminary sandblasting. Spray coatings from precursor solutions were reported to have thicknesses of 20−80 μm and adhesion strength less than 500 psi (regardless of the coupon surface finish). Cross-sectional views of the coatings confirmed subsurface porosity, and XRD results indicated that the coatings were polycrystalline, with patterns typical to that of cubic Er 2 O 3 and Y 2 O 3 .

Preparation and frictional characteristics of solid lubrication coating on CFRP surface

“…Thermal spraying preparation options include electroplating, laser cladding, flame spraying, etc. [22–25], cold spraying method does not need to melt the coating material at high temperature, and directly uses high-speed air to hit the material to be sprayed on the substrate to obtain a uniform and dense coating [26–29]. The bonding method is a suitable approach for creating solid lubricating coatings on CFRP-based substrates.…”