Communication: Thermodynamics of condensed matter with strong pressure-energy correlations

Self Cite

Non-equilibrium molecular dynamics simulations were performed to study the thermodynamic, structural, and dynamical properties of the single-component Lennard-Jones and the Kob-Andersen binary Lennard-Jones liquids. Both systems are known to have strong correlations between equilibrium thermal fluctuations of virial and potential energy. Such systems have good isomorphs (curves in the thermodynamic phase diagram along which structural, dynamical, and some thermodynamic quantities are invariant when expressed in reduced units). The SLLOD equations of motion were used to simulate Couette shear flows of the two systems. We show analytically that these equations are isomorph invariant provided the reduced strain rate is fixed along the isomorph. Since isomorph invariance is generally only approximate, a range of shear rates were simulated to test for the predicted invariance, covering both the linear and non-linear regimes. For both systems, when represented in reduced units the radial distribution function and the intermediate scattering function are identical for state points that are isomorphic. The strain-rate dependence of the viscosity, which exhibits shear thinning, is also invariant along an isomorph. Our results extend the isomorph concept to the non-equilibrium situation of a shear flow, in which the phase diagram is three dimensional because the shear rate defines a third dimension.

Section: Generating Isomorphic State Pointsmentioning

confidence: 99%

“…Another consequence of the isomorph theory is an expression for h(ρ) for atomic liquids with interaction potentials consisting of a sum of inverse power laws, v(r) = n v n r −n . For such liquids h(ρ) is given as follows [37,38] …”

Section: Generating Isomorphic State Pointsmentioning

confidence: 99%

Isomorph invariance of Couette shear flows simulated by the SLLOD equations of motion

Separdar

Bailey²,

Schrøder³

et al. 2013

Self Cite

“…The isomorph theory predicts "isomorph scaling", i.e., that the dynamics is a function of h(ρ)/T , where h(ρ) depends on the system [30,46]. For atomic systems interacting via a pair potential that is the sum of IPL potentials υ(r) = n υ n r −n , h(ρ) is given by h(ρ) = n C n ρ n/3 , where the constants C n are the fractional contributions of each term to the heat capacity [30,46].…”

Section: Isomorph Theorymentioning

confidence: 99%

Scaling of the dynamics of flexible Lennard-Jones chains

Veldhorst

Dyre

Schrøder

2014

Self Cite

The isomorph theory provides an explanation for the so-called power law density scaling which has been observed in many molecular and polymeric glass formers, both experimentally and in simulations. Power law density scaling (relaxation times and transport coefficients being functions of ρ γ S /T , where ρ is density, T is temperature, and γS is a material specific scaling exponent) is an approximation to a more general scaling predicted by the isomorph theory. Furthermore, the isomorph theory provides an explanation for Rosenfeld scaling (relaxation times and transport coefficients being functions of excess entropy) which has been observed in simulations of both molecular and polymeric systems. Doing molecular dynamics simulations of flexible Lennard-Jones chains (LJC) with rigid bonds, we here provide the first detailed test of the isomorph theory applied to flexible chain molecules. We confirm the existence of isomorphs, which are curves in the phase diagram along which the dynamics is invariant in the appropriate reduced units. This holds not only for the relaxation times but also for the full time dependence of the dynamics, including chain specific dynamics such as the end-to-end vector autocorrelation function and the relaxation of the Rouse modes. As predicted by the isomorph theory, jumps between different state points on the same isomorph happen instantaneously without any slow relaxation. Since the LJC is a simple coarse-grained model for alkanes and polymers, our results provide a possible explanation for why power-law density scaling is observed experimentally in alkanes and many polymeric systems. The theory provides an independent method of determining the scaling exponent, which is usually treated as a empirical scaling parameter.

“…Figure 2 displays the correlation between log(T g ) and log(V g ) that varies linearly only in the low-pressure regime. According to isomorph theory [27][28][29][30], the scaling exponent is not constant, but generally is a function of density. Thus, a natural question is whether the departures at higher pressures in our computations arise from using a constant value of γ.…”

Section: B Testing Thermodynamic Scalingmentioning

confidence: 99%

“…The study of thermodynamic scaling has triggered the proposal of several novel concepts by Dyre and coworkers, such as that of "strongly correlating liquids" (i.e., liquids with strong correlations between equilibrium fluctuations of the potential energy and the virial in a canonical ensemble) and "isomorphs" (i.e., curves in the phase diagram along which structure, dynamics, and some thermodynamic properties are invariant in reduced units) . [23][24][25][26][27][28] The isomorph theory indicates that the scaling exponent γ is not constant, but depends on density, [27][28][29][30] and the power-law form ρ γ is only a special case. However, the power-law density scaling is a useful approximation to the isomorph scaling since a number of experiments find a weak dependence of γ on density under certain thermodynamic conditions [4][5][6] and since using a constant value of γ leads to collapse onto a master curve of the dynamics in glass-forming liquids.…”

Section: Introductionmentioning

confidence: 99%

Thermodynamic scaling of dynamics in polymer melts: Predictions from the generalized entropy theory

Freed

2013

Many glass-forming fluids exhibit a remarkable thermodynamic scaling in which dynamic properties, such as the viscosity, the relaxation time, and the diffusion constant, can be described under different thermodynamic conditions in terms of a unique scaling function of the ratio ρ γ /T , where ρ is the density, T is the temperature, and γ is a material dependent constant. Interest in the scaling is also heightened because the exponent γ enters prominently into considerations of the relative contributions to the dynamics from pressure effects (e.g., activation barriers) vs. volume effects (e.g., free volume). Although this scaling is clearly of great practical use, a molecular understanding of the scaling remains elusive. Providing this molecular understanding would greatly enhance the utility of the empirically observed scaling in assisting the rational design of materials by describing how controllable molecular factors, such as monomer structures, interactions, flexibility, etc., influence the scaling exponent γ and, hence, the dynamics. Given the successes of the generalized entropy theory in elucidating the influence of molecular details on the universal properties of glass-forming polymers, this theory is extended here to investigate the thermodynamic scaling in polymer melts. The predictions of theory are in accord with the appearance of thermodynamic scaling for pressures not in excess of ∼ 50 MPa. (The failure at higher pressures arises due to inherent limitations of a lattice model.) In line with arguments relating the magnitude of γ to the steepness of the repulsive part of the intermolecular potential, the abrupt, square-well nature of the lattice model interactions lead, as expected, to much larger values of the scaling exponent. Nevertheless, the theory is employed to study how individual molecular parameters affect the scaling exponent in order to extract a molecular understanding of the information content contained in the exponent. The chain rigidity, cohesive energy, chain length, and the side group length are all found to significantly affect the magnitude of the scaling exponent, and the computed trends agree well with available experiments. The variations of γ with these molecular parameters are explained by establishing a correlation between the computed molecular dependence of the scaling exponent and the fragility. Thus, the efficiency of packing the polymers is established as the universal physical mechanism determining both the fragility and the scaling exponent γ.