2013 IEEE International Conference on Mechatronics and Automation 2013
DOI: 10.1109/icma.2013.6617997
|View full text |Cite
|
Sign up to set email alerts
|

Deformation and stress analysis of short flexspline in the harmonic drive system with load

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
4
1

Citation Types

0
9
0

Year Published

2016
2016
2022
2022

Publication Types

Select...
9
1

Relationship

1
9

Authors

Journals

citations
Cited by 18 publications
(9 citation statements)
references
References 5 publications
0
9
0
Order By: Relevance
“…Gao et al analyzed the sensitivity of structure parameters on the stress state of FS, but the influence of loads was not taken into account (Gao et al , 2012). Zou et al worked out the mesh force of gear and applied it on the tooth surface to analyze the deformation and stress of FS with load, but the CS was not considered (Zou et al , 2013). Wu et al established the model of FS and CS with teeth and defined contact pairs between the meshing teeth surfaces to simulate the mesh force, but the model ignored the effect of ball bearing (Wu et al , 2011).…”
Section: Introductionmentioning
confidence: 99%
“…Gao et al analyzed the sensitivity of structure parameters on the stress state of FS, but the influence of loads was not taken into account (Gao et al , 2012). Zou et al worked out the mesh force of gear and applied it on the tooth surface to analyze the deformation and stress of FS with load, but the CS was not considered (Zou et al , 2013). Wu et al established the model of FS and CS with teeth and defined contact pairs between the meshing teeth surfaces to simulate the mesh force, but the model ignored the effect of ball bearing (Wu et al , 2011).…”
Section: Introductionmentioning
confidence: 99%
“…reducers and conducted reliability evaluations on the strength failures of harmonic reducers through accelerated life testing; Zou et al [16] , Sun et al [17] , and Ma et al [18] focused on the structural failures of flexspline and flexible bearing and modeled the reliability of harmonic reducers using Monte Carlo simulation. Such fields have been studied a lot from both reliability testing and mechanism modeling.…”
Section: A Literature Reviewmentioning
confidence: 99%
“…They analyzed the stress and strain of flexible bearing using finite element method (FEM) analysis. Zou et al 9 treated wave generator (including flexible bearing) as a rigid body and studied the stress and deformation of flexspline under no-load and load conditions. But they did not analyze the mechanical properties.…”
Section: Introductionmentioning
confidence: 99%