Design and simulation of MEMS based sensor for early detection of PD

Prasad, G. R. K.; Babu, P. Srinivasa; Siddaiah, N.; Rao, K. Srinivasa

doi:10.1109/iceeccot.2016.7955247

Cited by 10 publications

(2 citation statements)

References 4 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The conversion is done using simple two bits in terms of representation i.e., '1's and '0's. In these binary bits '1' means high or ON and '0' means low or OFF, these are the terms used in computer world or any manufacturing technologies [11][12][13][14][15][16][17]. The Binary code is a weighted code, as it has positional weights whereas, Gray code is a nonweighted code, it does not have any positional weight.…”

Section: Relax Phasementioning

confidence: 99%

An Efficient Design of QCA Binary to Gray Code Converter for Telecommunication Systems

Aditya

Balaji

et al. 2022

Preprint

View full text Add to dashboard Cite

Quantum Dot Cellular Automata (QCA) is a prominent technology in Quantum Electronics. This is implemented with the help of quantum cells which are also known as basic building blocks of Quantum Electronics. In QCA technology there are four different clock pulses, clock delay for each clock cycle is 0.25 ns. Using this technology now we are implementing the Binary to Gray code converter. In this paper, we are proposing a design to reduce the number of cells when compared to the previous designs and we are also extending the implementation of the converter up to 5-bits. The number of cells in the proposed design is improved by 2.5%, 36.44%, and 50.66% for 2-bit, 3-bit, and 4-bit respectively. Also, for 3-bit and 4-bit, the total occupied area is improved by 55.56% and 74.680% respectively. In our proposed design it helps us to decrease the area from the previous circuit, which may also lead to the decrease in the power consumption.

show abstract

Section: Relax Phasementioning

confidence: 99%

An Efficient Design of QCA Binary to Gray Code Converter for Telecommunication Systems

Aditya

Balaji

et al. 2022

Preprint

View full text Add to dashboard Cite

show abstract

“…Further on application of a pulse modulated signal it can greatly reduce the static power dissipation. The widely-used detection mechanism of MEMS gas sensors was mostly dependent on the voltage divider [11].The dimensions of the sensor and the quantity of sensing materials determine the limits of temperature and heating time, because of the relation between thermal and active regions [12][13][14][15][16].The sensor shows good characteristics at CO2 due to a single cantilever. The working principle of the metal oxide based gas sensor is that it changes the resistance of the Sensing film by adsorption of the gas molecules over the surface of the semiconductor.…”

Section: Introductionmentioning

confidence: 99%

A Low Power Cantilever-Based Metal Oxide Semiconductor Gas Sensor for Green House Applications

Siddaiah¹

2019

IJETER

View full text Add to dashboard Cite

This paper discuss about the detection of gas using MEMS. The main purpose is to design a metal oxide semiconductor based gas sensor with different types of cantilevers We simulated a design with cylindrical, rectangular and we compare the results. By gas detection from the circuit, there has been wide measurement range and high resolution to fulfill an gas sensor. A width of 10μ cantilever on which a sensing material is used and placed on the platinum micro heater without coil, which will provide less consumption of power and better heating with in less time. The circuit has been designed with a metal-oxide semiconductor technology to reduce the power consumption and suggest the best physical architecture

show abstract