Postural and therefore biomechanical standardization in strength testing has not been rigorously and consistently applied. To develop a quantitative relationship between strength and posture (body position, symmetry, and reach) 30 normal subjects (18 male and 12 females) were required to stoop and squat lift or exert in the relevant posture against a standardized instrumented handle. The isometric lifting efforts and isokinetic lifts were studied. The isokinetic lifts were done at a linear velocity of 50cm/s of the hand displacement from the floor to the knuckle heights of the respective subjects in stoop and squat postures. The isometric stoop lifting efforts were exerted in two standardized postures: (a) with 60 degrees hip flexion; and (b) with 90 degrees hip flexion. The isometric squat lifting efforts were also exerted in two standardized postures: (a) with 90 degrees knee flexion; and (b) with 135 degrees knee flexion. All isometric lifting efforts and isokinetic lifts were performed at half, three-quarters, and full horizontal reach in sagitally symmetrical, 30 degrees left lateral, and 60 degrees left lateral planes. Isometric stoop and squat lifting efforts were also measured in self-selected optimal postures. These 56 conditions were tested in random order. The analysis of variance revealed that the gender, the mode of lifting, the postural asymmetry and reach of lifting affected the strength significantly (p less than 0.0001). Most two-way and three-way interactions were significant (p less than 0.01). Of 108 prediction regression equations, 103 were significant with up to 90% of the variation explained by anthropometric variables and sagittal plane strength. The reach affected the strength most profoundly followed by postural asymmetry and the mode of lifting.