Development of a real-time active pipeline integrity detection system

Abstract

Utilizing the SMART Layer technology as a basis, a real-time active pipeline integrity detection (RAPID) system is developed for built-in in situ assessment of the health of new and existing pipelines. The RAPID system consists of a sensor network permanently mounted on the host pipeline, portable electronic hardware and diagnostic software. Three moduli, including image display, damage sizing, and corrosion depth, are built into the diagnostic software to help in visualization of the approximate location and the extent of corrosion, and to quantify the corrosion sizing and depth. The main advantages of the RAPID system include: (1) ease of use, (2) ability to provide a well-defined resolution, (3) reliability with self-diagnostic and environmental compensation, and (4) quantified corrosion sizing. To verify the detection capability of the RAPID system, a series of tests have been conducted on a 6.7 m long steel pipe with a diameter of 610 mm and a wall thickness of 7.14 mm with ten different types of corrosion flaws. Test results demonstrated that the depth detection limit could be as low as 0.125 mm for general corrosion with an area of 60 mm × 60 mm under laboratory conditions, while a pinhole with 6.35 mm diameter and 3.5 mm depth can be detected with the given sensor density. Some practical issues for field applications of the RAPID system are also discussed.

Structural health monitoring: Closing the gap between research and industrial deployment

“…69,70 This is connected to instrumentation that can transmit the data either wirelessly or via wired connections to an analysis centre where bespoke software assesses whether any damage is present and its severity. It was originally developed for aerospace applications but multiple potential applications have been proposed.…”

A probabilistic crack size quantification method using in-situ Lamb wave test and Bayesian updating

“…due to that the transmission mechanism for Lamb wave remains obscure. For damage evaluation, most studies adopted damage indexes to quantify the crack size [13][14][15][16]. Damage indexes can be extracted from Lamb wave signals in the time domain, frequency domain and time-frequency domain by different signal processing method.…”

Autonomous self-powered structural health monitoring system

“…As shown in Figure 15, 30 PZTs with a thickness of 10 mil (0.25 mm) and a diameter of ¼ inch (6.35 mm) were mounted on the back surface of the composite panel. The SmartComposite software was used to analyze the sensor signals, and further calculate the size and location of the impact damage [13,14]. The detection results are shown in Figures 16 and 17.…”