Development of UHF to 2.4GHz and 5.2GHz dual band up-conversion CMOS mixer

Miyamoto, Ryoya; Galal, A. I. A.; Kanaya, Haruichi

doi:10.1109/eptc.2016.7861471

Cited by 2 publications

(2 citation statements)

References 5 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Key sight ADS 26 tool is used for the design and analysis of the cascaded LNA simulation. The LNA is designed with the ATF-36163 which draws 12 mA from the 2.4V supply.…”

Section: Measurement and Analysismentioning

confidence: 99%

“…Implementing Intelligent Traffic Control System for Congestion Control has been described 23 . The different development of active integrated circuit mixer for wireless transmitter application has been reported in the context of vehicular communication and ITS [24][25][26][27] . The problems of choice of road route under conditions of uncertainty which drivers are faced with as they carry out their task of transportation have been described 28 .…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Design of RF Receiver Front end Subsystems with Low Noise Amplifier and Active Mixer for Intelligent Transportation Systems Application

et al. 2020

View full text Add to dashboard Cite

This paper presents the design, simulation, and characterization of a novel low-noise amplifier (LNA) and active mixer for intelligent transportation system applications. A low noise amplifier is the key component of RF receiver systems. Design, simulation, and characterization of LNA have been performed to obtain the optimum value of noise figure, gain and reflection coefficient. Proposed LNA achieves measured voltage gains of ~18 dB, reflection coefficients of -20 dB, and noise figures of ~2 dB at 5.9 GHz, respectively. The active mixer is a better choice for a modern receiver system over a passive mixer. Key sight advanced design system in conjunction with the electromagnetic simulation tool, has been to obtain the optimal conversion gain and noise figure of the active mixer. The lower and upper resonant frequencies of mixer have been obtained at 2.45 GHz and 5.25 GHz, respectively. The measured conversion gains at lower and upper frequencies are 12 dB and 10.2 dB, respectively. The measured noise figures at lower and upper frequencies are 5.8 dB and 6.5 dB, respectively. The measured mixer interception point at lower and upper frequencies are 3.9 dBm and 4.2 dBm.

show abstract

“…Key sight ADS 26 tool is used for the design and analysis of the cascaded LNA simulation. The LNA is designed with the ATF-36163 which draws 12 mA from the 2.4V supply.…”

Section: Measurement and Analysismentioning

confidence: 99%