Development of ZrB₂-Based Single Layer Absorber Coating and Molten Salt Corrosion of Bulk ZrB₂–SiC Ceramic for Concentrated Solar Power Application

Abstract

This study has dual objectives, one to develop single layer ZrB2–SiC-based ceramic absorber coating on stainless substrate, and another aim is to explore the degradation of ZrB2–SiC bulk ceramic in molten solar salt. In particular, we report the molten salt corrosion behavior of earlier developed ZrB2–SiC ceramic composite at 400 °C for 100 h. The corrosion rate in solar salt was determined to be 0.73 ± 0.09 mg h–1/cm2 by gravimetric analysis. Binary and ternary oxide phases were formed due to electrochemical corrosion. The hot-pressed bulk ZrB2–SiC ceramic exhibits a high solar absorptance of 0.848 and also a high thermal emissivity of 0.66. A one-layer solar selective absorber coating without antireflection layer was developed using the ceramic disk as a sputtering target. When deposited using radio frequency (RF) magnetron sputtering technique on stainless steel substrate, a solar absorptance of 0.769 and thermal emissivity of 0.15 was obtained for an amorphous coating of thickness ∼90 nm, without antireflection coating. The composition, determined by electron probe microanalyzer and X-ray photoelectron spectroscopy techniques, revealed nonstoichiometric phases in the layer with a relatively higher concentration of the lighter elements. The implication of the present work for concentrated solar power application is discussed.

Probing the spectrally selective property of NbB2‐based tandem absorber coating for concentrated solar power application

“…[12][13][14] In recent years, the borides have also gained more attention. [15][16][17][18][19] The possible application of bulk borides, such as ZrB 2 , HfB 2 , TaB 2 , TiB 2 , and LaB 6 , have been reported lately. [19][20][21] Also, these borides were combined with metals and dielectrics and fabricated into multilayer solar selective coatings.…”

“…Among UHTCs, nitrides and carbides have been widely explored as potential solar selective materials for CSP application 12–14 . In recent years, the borides have also gained more attention 15–19 . The possible application of bulk borides, such as ZrB 2 , HfB 2 , TaB 2 , TiB 2 , and LaB 6 , have been reported lately 19–21 .…”