Diagnostics of Corrosion Protection Potential for Electric Water Heaters

Abstract

The paper represents the mathematical model for diagnostics of the corrosion protection potential for the electric water heaters (EWH). The research objectives are the problem of determining the EWH corrosion protection technical condition during its operation. The EWH corrosion protection diagnostics is based on the mathematical model of the corrosion protection potential for EWH. The model is based on the nonlinear equivalent circuit which is modelling the nonlinear impedance of the corrosion cathodic protection. In the development of the mathematical model the authors carried out experimental measurements of the impedance for the EWH body fragment. The obtained experimental results show that mathematical model includes the fractional integrating elements. By using of the experimental results the expressions of the impedance, the impulse response is obtained. The methodological approach to increasing the reliability of the EWH corrosion protection diagnostics has been proposed, in terms of the multi-parameter diagnostics, by applying the EWH corrosion protection impedance model.

Impact of the epidemiological situation in Poland in 2020 on the public transport system

“…The effectiveness of the enterprise, measured by economic results, is directly influenced by both downtime of technological devices caused by failure of their components and planned maintenance and reconstruction of the utility (repair) potential [6]. Due to the unforeseen epidemiological situation, many of the transport companies began to generate much higher costs due to the necessity to maintain sanitary requirements, disinfection etc., and to bring lower profits due to the decrease in the number of users [7][8][9]. The number of vehicle kilometers performed in individual quarters in 2019 and 2020 are at a similar level (in 2020 they were enforced by sanitary regulations limiting the number of passengers on public transport).…”

Systems of vibration parameters automated control for diagnostics of equipment technical state

“…In most cases, the purpose of vibration measurements is to monitor the operating conditions of the shaft and bearing. The sensor should be installed so that mechanical vibrations of the bearing act directly on its working surface [15,16,17]. The sensor 3 perceives the mechanical oscillations of the bearing with less vibration, which is disturbed by other components and parts of the unit, compared to sensor 4, which receives the transformed bearing oscillations and mechanical oscillations when passing through the LF2 AD12 2 ALD IDП RAM S1 A1 LF1 AD21 OD detachable connection, generated by other units.…”