Direct powers control of DFIG through direct converter and sliding mode control for WECS

Boumassata, A.; Kerdoun, Djallel

doi:10.1109/ceit.2015.7233058

Cited by 3 publications

(2 citation statements)

References 10 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In this paper, the interest is given to one of the most commonly used MPPT strategy that is the Optimal Power-MPPT (OP-MPPT). With this strategy, this objective can be achieved in the second operating zone when the wind speed is below its nominal value and without wind speed measurements [28,29].…”

Section: A Maximum Power Point Tracking Techniquementioning

confidence: 99%

Active and Reactive Power Control of Wind Turbine based on Doubly Fed Induction Generator using Adaptive Sliding Mode Approach

Zamzoum¹,

Mourabit²,

Errouha³

et al. 2019

ijacsa

View full text Add to dashboard Cite

In this work, a robust Adaptive sliding mode controller (ASMC) is proposed to improve the dynamic performance of the Doubly Fed Induction generator (DFIG) based wind system under variable wind speed conditions. Firstly, the dynamic modeling of the main components of the system is performed. Thereafter, the ASMC is designed to control the active and reactive powers of the machine stator. The structure of these controllers was improved by adding two integral terms. Their sliding gains are determined using Lyapunov stability theorem to make them automatically adjusted in order to tackle the external disturbances. Maximum Power Point Tracking (MPPT) strategy was also applied to enhance the power system efficiency. Then, a comparison study with the Field Oriented Control (FOC) based on conventional PI control was conducted to assess the robustness of this technique under the DFIG parameters variations. Finally, a computer simulation was achieved in MATLAB/SIMULINK environment using 2MW wind system model. Satisfactory performances of the proposed strategy were clearly confirmed under variable operating conditions.

show abstract

Section: A Maximum Power Point Tracking Techniquementioning

confidence: 99%

Active and Reactive Power Control of Wind Turbine based on Doubly Fed Induction Generator using Adaptive Sliding Mode Approach

Zamzoum¹,

Mourabit²,

Errouha³

et al. 2019

ijacsa

View full text Add to dashboard Cite

show abstract

“…The earth climate can be seriously influenced by increasing green house gas emissions from conventional energy sources (such as oil and coal) as well as the growing concern of depletion of these resources in the near future [1].Wind turbine is one way to generate electricity from renewable sources, mainly because it is clean and economically viable [2]. At the same time, there has been a rapid development of related wind turbine [3].…”

Section: Introductionmentioning

confidence: 99%

Comparative study between sliding mode control and the vector control of a brushless doubly fed reluctance generator based on wind energy conversion systems

Oualah

Kerdoun

Boumassata

2022

Electrical Engineering & Electromechanics

View full text Add to dashboard Cite

Introduction. Nowadays, global investment in renewable energy sources has been growing intensely. In particular, we mention here that wind source of energy has grown recently. Purpose. Comparative study between sliding mode control and vector control of a brushless doubly fed reluctance generator based on wind energy conversion systems. Methods. This paper deals with conceptual analysis and comparative study of two control techniques of a promising low-cost brushless doubly-fed reluctance generator for variable-speed wind turbine considering maximum power point tracking. This machine's growing interest because of the partially rated power electronics and the high reliability of the brushless design while offering performance competitive to its famous spring counterpart, the doubly-fed induction generator. We are particularly interested in comparing two kinds of control methods. We indicate here the direct vector control based on Proportional-Integral controller and sliding mode controller. Results. Simulation results show the optimized performances of the vector control strategy based on a sliding mode controller. We observe high performances in terms of response time and reference tracking without overshoots through the response characteristics. The decoupling, the stability, and the convergence towards the equilibrium are assured.

show abstract

Fault Detection and Control Reconfiguration of Wind Power Plants

Karim

Tadjine

Allaoui

2019

2019 6th International Conference on Electrical and Electronics Engineering (ICEEE)

View full text Add to dashboard Cite

Direct powers control of DFIG through direct converter and sliding mode control for WECS

Cited by 3 publications

References 10 publications

Active and Reactive Power Control of Wind Turbine based on Doubly Fed Induction Generator using Adaptive Sliding Mode Approach

Active and Reactive Power Control of Wind Turbine based on Doubly Fed Induction Generator using Adaptive Sliding Mode Approach

Comparative study between sliding mode control and the vector control of a brushless doubly fed reluctance generator based on wind energy conversion systems

Fault Detection and Control Reconfiguration of Wind Power Plants

Contact Info

Product

Resources

About