Effect of annealing conditions on the superconducting properties of nano-sized metallic Au-added Bi1.8Sr2Au0.2Ca1.1Cu2.1Oy (Bi-2212) ceramics

Özkurt, Berdan

doi:10.1007/s10854-020-03693-0

Cited by 4 publications

(1 citation statement)

References 57 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…On the other hand, the interconnections of the wires arranged as a network are similar for all samples. For superconducting materials, there is a high dependence of the capacity to transport superconducting currents with the connectivity among the grains [30,31] and the wires [32]. This is further discussed in section 3.4.…”

Section: Scanning Electron Microscopymentioning

confidence: 99%

Optimum heat treatment to enhance the weak-link response of Y123 nanowires prepared by Solution Blow Spinning

Caffer¹,

Chaves²,

Pessoa³

et al. 2021

Supercond. Sci. Technol.

View full text Add to dashboard Cite

Although the production of YBa2Cu3O7-δ (Y123) has been extensively reported, there is still a lack of information on the ideal heat treatment to produce this material in the form of one dimension nanostructures. Thus, by means of the Solution Blow Spinning technique, metals embedded in polymer fibers were prepared. These polymer composite fibers were fired and then investigated by thermogravimetric analysis. The maximum sintering temperatures of heat treatment were chosen in the interval 850 °C–925 °C for 1 h under oxygen flux. SEM images allowed us to determine the wire diameter as approximately 350 nm for all samples, as well as to map the evolution of the entangled wire morphology with the sintering temperature. XRD analysis indicated the presence of Y123 and secondary phases in all samples. Ac magnetic susceptibility and dc magnetization measurements demonstrated that the sample sintered at 925 °C/1 h is the one with the highest weak-link critical temperature and the largest diamagnetic response.

show abstract

Section: Scanning Electron Microscopymentioning

confidence: 99%