2012
DOI: 10.1016/j.cryobiol.2012.05.010
|View full text |Cite
|
Sign up to set email alerts
|

Effect of common cryoprotectants on critical warming rates and ice formation in aqueous solutions

Abstract: Ice formation on warming is of comparable or greater importance to ice formation on cooling in determining survival of cryopreserved samples. Critical warming rates required for ice-free warming of vitrified aqueous solutions of glycerol, dimethyl sulfoxide, ethylene glycol, polyethylene glycol 200 and sucrose have been measured for warming rates of order 10 to 104 K/s. Critical warming rates are typically one to three orders of magnitude larger than critical cooling rates. Warming rates vary strongly with coo… Show more

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
1
1
1
1

Citation Types

1
50
0

Year Published

2014
2014
2022
2022

Publication Types

Select...
4
4
1

Relationship

0
9

Authors

Journals

citations
Cited by 57 publications
(51 citation statements)
references
References 60 publications
(151 reference statements)
1
50
0
Order By: Relevance
“…[7,8] However, even if this is achieved, rewarming requires a much faster critical warming rate (CWR), such as 50 °C min −1 for VS55 [8c] to avoid devitrification (i.e., ice formation during the rewarming). [9] Convective heating by immersion in a warm water bath is adequate for samples with volumes below 3 mL and cells in suspension or small tissues in a cryovial or cryobag. However, convective warming is often too slow to achieve needed CWR in larger samples (>3 mL) due to the inability to quickly warm the center of the sample, thereby leading to devitrification.…”
Section: Introductionmentioning
confidence: 99%
“…[7,8] However, even if this is achieved, rewarming requires a much faster critical warming rate (CWR), such as 50 °C min −1 for VS55 [8c] to avoid devitrification (i.e., ice formation during the rewarming). [9] Convective heating by immersion in a warm water bath is adequate for samples with volumes below 3 mL and cells in suspension or small tissues in a cryovial or cryobag. However, convective warming is often too slow to achieve needed CWR in larger samples (>3 mL) due to the inability to quickly warm the center of the sample, thereby leading to devitrification.…”
Section: Introductionmentioning
confidence: 99%
“…5 and Movie S4 and summarized together with the cooling and survival rates in Table 1. The estimated warming rates were approximately three to four times higher than the corresponding cooling rates, whereas the critical warming rates of several solutions were reported to be one to three orders of magnitude higher than the CCR (32). The critical warming rate for cells (CWR cell ) was estimated to be 10 5°C /s, which is one order of magnitude higher than CCR cell .…”
Section: Resultsmentioning
confidence: 84%
“…Recent studies have considered the role of warming rates in determining the fate of vitrified cells [18,22]. According to Hopkins et al [23] differences in warming rates are correlated directly with prior cooling rate because of the accumulation of tiny ice fragments in vitrified cells. A faster cooling rate is required for a corresponding warming rate to block recrystallization [22].…”
Section: Vitrification: High Warming and Cooling Rate Methodsmentioning
confidence: 99%