Effect of deposition temperature on structural, surface, optical and magnetic properties of pulsed laser deposited Al-doped CdO thin films

A study of Tin doping effects on physical properties of CdO thin films prepared by sol–gel spin coating method

“…As the Sn concentration increases from 0 to 5 wt%, the resistivity decreases from 2.56 × 10 −2 cm to the minimum value of 1.12 × 10 −4 cm. The obtained resistivity value (1.12 × 10 −4 cm) is lower than Sn doped CdO thin films prepared by pulsed laser deposition method (1.59 × 10 −4 cm) [3] chemical bath deposition (8 × 10 −4 cm) [21] and metal organic chemical vapor deposition (3.1 × 10 −4 cm) [27]. The un-doped CdO thin film exhibit a carrier concentration of 0.81 × 10 21 cm −3 .…”

The structural, magnetic, and optical properties of Ni–Mg–Zn ferrite prepared with different complexing agents via sol–gel method

“…At the same time, the W-H method has a less weight on data from higher angles. The dislocation line density (δ) of the prepared samples are given by the following formula [32]:…”

“…Ni-Mg-Zn ferrite has a broad application prospect as a typical soft magnetic material with a small magnetocrystalline anisotropy constant. Many researchers synthesize ferrite with some conventional technology including electrospinning method, microwave method, rheological phase reaction method, sol-gel method, solid phase method, microemulsion method, mechanochemical reaction method, etc [17][18][19][20][21][22][23][24][25]. In all synthesis methods, the sol-gel method is one of the simple, cheap and versatile techniques, which quickens the synthesis of compounds, lets surface morphology fine and makes crystal homogeneity.…”

Controllable synthesis of La3+ dopedZn0.5Co0.25Cu0.25Fe2−xLRehman1, Morley2, Amin3 et al. 2020Ceramics International59140View full textAdd to dashboardCite

“…The dislocation line density ( ) [41] of ferrite samples was found to increase by raising the La 3+ content and is reported in Table 1. The calculated values of X-ray density ( ) [42,43] are 2) show the same trend with variation in La 3+ content as the experimental lattice constant, and similar behavior as reported by Ganure et al [45].…”