Effect of input parameters on MRR and EWR for tool steel AISI L2 by electric discharge machine (EDM)

Aghdeab, Shukry H.; Shwaish, Raed R.; Salman, Tahseen M.

doi:10.1088/1757-899x/1076/1/012071

Cited by 5 publications

(1 citation statement)

References 6 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The frequency of discharges during a given period increases as the pulse off time decreases, resulting in a greater MRR. The average discharge gap widens as the gap voltage rises, resulting in a decreased MRR [23,24]. Wire feed and reinforcement have no major effects on MRR.…”

Section: Analysis Of Mrrmentioning

confidence: 99%

Wire Electrical Discharge Machining (WEDM) of Hybrid Composites (Al-Si12/B4C/Fly Ash)

Prakash

Sivaprakasam

Garip

et al. 2021

Journal of Nanomaterials

View full text Add to dashboard Cite

The present study looks into the effect of WEDM process parameters on the material removal rate (MRR) and surface roughness (SR) responses when machining hybrid composites (Al-Si12/boron carbide/fly ash) using the Taguchi technique. Fly ash and boron carbide (B4C) particles were used for reinforcement (3%, 6%, and 9% by weight), and aluminium alloy (Al-Si12) was used as a matrix material. ANOVA was used to find out the importance of machining factors that affect the quality features of the WEDM process, as well as the relative role of input parameters in determining the WEDM process’ responses. The greatest impact on the response is finalised by the signal-to-noise (S/N) ratio response analysis. However, as a last step, a confirmation experiment with the best combination was carried out to predict and validate the accuracy of the observed values. As the pulse on time and reinforcement increases, MRR also increases. As the gap voltage, wire feed, and pulse off time decrease, it increases. SR is increased by increasing the gap voltage, pulse on time, and pulse off time, wire feed, and reinforcement. The maximum MRR of 38.01 mm3/min and the minimum SR of 3.24 μm were obtained using optimal machining conditions.

show abstract

Section: Analysis Of Mrrmentioning

confidence: 99%