2019
DOI: 10.1016/j.cej.2018.09.202
|View full text |Cite
|
Sign up to set email alerts
|

Effect of pore size distribution and particle size of porous metal oxides on phosphate adsorption capacity and kinetics

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
2
1
1
1

Citation Types

6
49
0

Year Published

2019
2019
2024
2024

Publication Types

Select...
7
1

Relationship

1
7

Authors

Journals

citations
Cited by 223 publications
(55 citation statements)
references
References 54 publications
6
49
0
Order By: Relevance
“…In surface characteristics, porosity is essential to investigate the adsorption potential of MO particles in antimicrobial actions [34]. Large mesopores (10-50 nm) in MO particles induce fast biochemical adsorption on the particle surfaces, which has contributed to enhanced reaction rate, compared to small mesopores (2-10 nm).…”
Section: Discussionmentioning
confidence: 99%
“…In surface characteristics, porosity is essential to investigate the adsorption potential of MO particles in antimicrobial actions [34]. Large mesopores (10-50 nm) in MO particles induce fast biochemical adsorption on the particle surfaces, which has contributed to enhanced reaction rate, compared to small mesopores (2-10 nm).…”
Section: Discussionmentioning
confidence: 99%
“…For adsorption, the chemical costs were calculated for porous metal oxide assuming that it is reused successfully for 30 cycles. Even if the equilibrium adsorption capacity for this adsorbent (FSP) at 1 mg P/L is considered as the practical loading value (Suresh Kumar et al., 2019), the cost to reduce phosphate concentrations from 10 to 1 mg P/L is around $ 35/Kg P. However, as the phosphate concentration goes lower, the costs for adsorption compete and eventually better those of precipitation (see Fig. 9 (b)).…”
Section: Economic Analysis For Phosphate Adsorptionmentioning
confidence: 99%
“…On the other hand, 96% of phosphate removal was achieved within 30 min in a macroporous (pore size > 50 nm) adsorbent (Yang et al., 2012). In a study comparing phosphate adsorption onto different porous metal oxides, it was determined that pores bigger than 10 nm are required to enhance phosphate adsorption kinetics (Suresh Kumar et al., 2019). This shows the need to characterize the pore structure of the adsorbents along with their surface area to ensure good phosphate adsorption kinetics.…”
Section: Introductionmentioning
confidence: 99%
“…The characterization and the effect of the particle size toward the physicochemical properties of the zeolite adsorptivity on the ammonia were studied in detail. The common analysis of the particle size in adsorption activities is normally reported in the powder suspension form of adsorbent [29,31]. The analysis of particle size effect incorporating with the membrane configuration is the novelty of this current work.…”
Section: Natural Zeolite Hfcm Fabrication and Characterisationmentioning
confidence: 99%
“…Particle size significantly affects membrane properties in terms of mechanical strength, porosity, and water permeability [28]. In addition, a small particle size offers a high surface area, resulting in a large number of active sites [29]. This property eventually increases the adsorptivity of the membrane in ammonia removal.…”
Section: Introductionmentioning
confidence: 99%