Effects of Cr-doping on the optical and magnetic properties in ZnO nanoparticles prepared by sol–gel method

Liu, Yang; Yang, Jing; Guan, Qingxin; Yang, Lili; Zhang, Yongjun; Wang, Yaxin; Feng, Bo; Cao, Jianliang; Liu, Xiaoyan; Yang, Yanting; Wei, Maobin

doi:10.1016/j.jallcom.2009.07.076

Cited by 133 publications

(48 citation statements)

References 30 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…Liu et al [32] indicated that point defects such as Zn i or V Zn are responsible for ferromagnetism in Cr:ZnO samples and Hong et al [47] have pointed out that the magnetization in their Cr:ZnO films is related to oxygen vacancies (V o ). Furthermore, Liu et al [48] suggested that two key factors lead to the appearance of ferromagnetism in TM-doped ZnO nanocrystals: one is the increase of the number of defects and oxygen vacancies, the other is the exchange interactions between the TM ions and the O ion spin moment.…”

Section: Resultsmentioning

confidence: 99%

Structural, optical and magnetic properties of Ni-doped ZnO micro-rods grown by the spray pyrolysis method

Yılmaz

McGlynn

Bacaksız

et al. 2012

Chemical Physics Letters

View full text Add to dashboard Cite

Undoped and Ni-doped ZnO micro-rod arrays were successfully synthesized by the spray pyrolysis method on glass substrates. Analysis of the samples with x-ray diffraction and scanning electron microscopy showed that these micro-rod arrays had a polycrystalline wurtzite structure with a highly c-axis preferred orientation. Photoluminescence studies at both 300 K and 10 K show that the incorporation of nickel leads to a relative increase in the visible blue light band intensity. Magnetic measurements indicated that Ni-doped ZnO samples exhibit ferromagnetic behavior at room temperature, which is possibly related to the presence of point defects.

show abstract

Section: Resultsmentioning

confidence: 99%

Structural, optical and magnetic properties of Ni-doped ZnO micro-rods grown by the spray pyrolysis method

Yılmaz

McGlynn

Bacaksız

et al. 2012

Chemical Physics Letters

View full text Add to dashboard Cite

show abstract

“…Until now, ZnO nanostructures have been fabricated by chemical solution deposition method [9,10], physical vapor deposition [11][12][13][14], pulsed laser deposition [15] and sol-gel process [16][17][18][19]. Among these methods, the sol-gel technique has great advantages due to its simplicity, safety, high turnout and low cost.…”

Section: Introductionmentioning

confidence: 99%

Tunable deep-level emission in ZnO nanoparticles via yttrium doping

Yang

Wang

Yang

et al. 2011

Journal of Alloys and Compounds

Self Cite

View full text Add to dashboard Cite

“…Liu et al 66 indicated that point defects such as Zn i or V Zn are responsible for ferromagnetism in Cr:ZnO samples. Furthermore, Liu et al 67 suggested that two key factors lead to the appearance of ferromagnetism in TMdoped ZnO nanocrystals: one is the increase of the number of defects and oxygen vacancies and the other is the exchange interactions between the TM ions and the O ion spin moment.…”

Section: Resultsmentioning

confidence: 99%

Effects of Cu diffusion-doping on structural, optical, and magnetic properties of ZnO nanorod arrays grown by vapor phase transport method

Yılmaz¹,

McGlynn²,

Bacaksız³

et al. 2012

Journal of Applied Physics

View full text Add to dashboard Cite

Realization of a 33 GHz phononic crystal fabricated in a freestanding membrane AIP Advances 1, 042001 (2011) Preparation of uncapped CdSe1xSx semiconducting nanocrystals by mechanical alloying J. Appl. Phys. 110, 124306 (2011) Formation mechanisms of spatially-directed zincblende gallium nitride nanocrystals J. Appl. Phys. 110, 124307 (2011) Surface modification of monocrystalline zinc oxide induced by high-density electronic excitation J. Appl. Phys. 110, 124310 (2011) Investigation of poly(o-anisidine)-SnO2 nanocomposites for fabrication of low temperature operative liquefied petroleum gas sensor J. Appl. Phys. 110, 124501 (2011) Additional information on J. Appl. Phys. Well-aligned ZnO nanorods were prepared by the vapor phase transport method on Si covered with a ZnO buffer layer. After the nanostructure growth, Cu was doped into the ZnO nanorods by diffusion at three different temperatures and for different times. Undoped and Cu diffusion-doped ZnO samples are highly textured, with the c axis of the wurtzite structure along the growth direction. The incorporation of Cu caused some slight changes in the nanorod alignment, although the wurtzite crystal structure was maintained. X-ray photoelectron spectroscopy measurements revealed that Cu ions were in a divalent state and substituted for the Zn 2þ ions of the ZnO matrix. Photoluminescence results at 10 K indicate that the incorporation of copper leads to a relative increase of Cu-related structured green band deep level intensity. Magnetic measurements revealed that both undoped and Cu diffusion-doped ZnO samples exhibited room temperature ferromagnetism. It was also found that bound magnetic polarons play an important role in the appearance of room temperature ferromagnetism in Cu diffusion-doped ZnO nanorods.

show abstract

Effects of Cr-doping on the optical and magnetic properties in ZnO nanoparticles prepared by sol–gel method

Cited by 133 publications

References 30 publications

Structural, optical and magnetic properties of Ni-doped ZnO micro-rods grown by the spray pyrolysis method

Structural, optical and magnetic properties of Ni-doped ZnO micro-rods grown by the spray pyrolysis method

Tunable deep-level emission in ZnO nanoparticles via yttrium doping

Effects of Cu diffusion-doping on structural, optical, and magnetic properties of ZnO nanorod arrays grown by vapor phase transport method

Contact Info

Product

Resources

About