Effects of Extraction Process Factors on the Composition and Antioxidant Activity of Blackthorn (Prunus spinosa L.) Fruit Extracts

Abstract

This study aimed at establishing the optimal conditions for the classic extraction of phenolic compounds from Prunus spinosa L. fruits. The effects of different parameters, i.e., ethanol concentration in the extraction solvent (mixture of ethanol and water), operation temperature, and extraction time, on process responses were evaluated. Total phenolic content (TPC), total anthocyanin content (TAC), antioxidant capacity (AC), and contents of protocatechuic acid (PA), caffeic acid (CA), vanillic acid (VA), rutin hydrate (RH), and quercetin (Q) of fruit extracts were selected as process responses. A synergistic effect of obtaining high values of TPC, TAC, AC, PA, and VA was achieved for the extraction in 50% ethanol at 60 °C for 30 min. At a higher level of process temperature, the extraction of protocatechuic acid and vanillic acid was enhanced, but the flavonoids, i.e., rutin hydrate and quercetin, were degraded. A lower temperature should be used to obtain a higher amount of flavonoids. TPC, TAC, AC, and phenolic acid contents (PA, CA, and VA) in the extract samples obtained at an ethanol concentration of 50–100%, a temperature of 30–60 °C, and an extraction time of 30 min were strongly directly correlated.

Ultrasound Assisted Alkaline Pretreatment of Biomass to Enhance the Extraction Yield of Valuable Chemicals

“…Accordingly, statistical models expressed by Equations ( 5) and (6) can be applied to estimate the process performance for factor levels within the ranges considered in the experimental study. Desirability function approach was applied to identify the optimal factor levels to maximize the process responses [29]. Profiles of predicted values of process responses and desirability function (d) at different levels of dimensionless factors, which are shown in Figure 4, highlight the following optimal levels of process factors: x1,opt = 0.5 (RSL,opt = 1.25 g/100 mL), x2,opt = 1 (Aopt = 60%), and x3,opt = 1 (topt = 50 °C).…”

Lavandula pedunculata Polyphenol-Rich Extracts Obtained by Conventional, MAE and UAE Methods: Exploring the Bioactive Potential and Safety for Use a Medicine Plant as Food and Nutraceutical Ingredient

“…The primary extraction objective was to obtain the desired BCs with high extraction yields while reducing the concentration of unwanted compounds, such as proteins and sugars, which could affect the stability and quality of the final extract. The extraction efficiency may be affected by several factors, the most important of which are the solvent, mass-to-solvent ratio, temperature, and pH [27]. The variables regarding the type of solvent and ratio were fixed because one of the main goals of this research study was to develop extracts by applying distinct techniques and evaluating their impact.…”

Bacterial Cellulose and Biodegradable Superbase for Heterogeneous Transesterification to Alkyl Esters

“…A desirability function approach was used to determine the optimum factor levels to maximize the FAME phase yield (Y pred = Y). A desirability function, d(Y), is defined by Equation (3), where L Y and U Y (Figure 11) are the lower and upper limits of response Y [25,26]. A completely desirable value of response corresponds to d(Y) = 1, whereas d(Y) = 0 represents an undesirable value.…”