Abstract:Identifying the influence of neotectonics on the morphology of elevated passive margins is complicated in that major morpho‐structural patterns might plausibly be explained by processes related to late Mesozoic to early Cenozoic rifting and/or differential erosion induced by Cenozoic epeirogenic uplift. The proportional contribution of each process can vary from continent to continent, and potentially even within the same passive margin.
In the passive margin setting of the southeast Australian highlands the d… Show more
“…The Tennant Creek rupture has been treated by multiple authors as a single rupture length for fault scaling relationships [7,8,104,139,140] and hazard mapping [119,141,142] as opposed to three separate earthquakes and associated ruptures [6,[143][144][145], a decision which significantly changes the length to magnitude ratio and slip distribution relative to an averaged epicentre location and magnitude.…”
We digitize surface rupture maps and compile observational data from 67 publications on ten of eleven historical, surface-rupturing earthquakes in Australia in order to analyze the prevailing characteristics of surface ruptures and other environmental effects in this crystalline basement-dominated intraplate environment. The studied earthquakes occurred between 1968 and 2018, and range in moment magnitude (Mw) from 4.7 to 6.6. All earthquakes involved co-seismic reverse faulting (with varying amounts of strike-slip) on single or multiple (1–6) discrete faults of ≥ 1 km length that are distinguished by orientation and kinematic criteria. Nine of ten earthquakes have surface-rupturing fault orientations that align with prevailing linear anomalies in geophysical (gravity and magnetic) data and bedrock structure (foliations and/or quartz veins and/or intrusive boundaries and/or pre-existing faults), indicating strong control of inherited crustal structure on contemporary faulting. Rupture kinematics are consistent with horizontal shortening driven by regional trajectories of horizontal compressive stress. The lack of precision in seismological data prohibits the assessment of whether surface ruptures project to hypocentral locations via contiguous, planar principal slip zones or whether rupture segmentation occurs between seismogenic depths and the surface. Rupture centroids of 1–4 km in depth indicate predominantly shallow seismic moment release. No studied earthquakes have unambiguous geological evidence for preceding surface-rupturing earthquakes on the same faults and five earthquakes contain evidence of absence of preceding ruptures since the late Pleistocene, collectively highlighting the challenge of using mapped active faults to predict future seismic hazards. Estimated maximum fault slip rates are 0.2–9.1 m Myr-1 with at least one order of uncertainty. New estimates for rupture length, fault dip, and coseismic net slip can be used to improve future iterations of earthquake magnitude—source size—displacement scaling equations. Observed environmental effects include primary surface rupture, secondary fracture/cracks, fissures, rock falls, ground-water anomalies, vegetation damage, sand-blows / liquefaction, displaced rock fragments, and holes from collapsible soil failure, at maximum estimated epicentral distances ranging from 0 to ~250 km. ESI-07 intensity-scale estimates range by ± 3 classes in each earthquake, depending on the effect considered. Comparing Mw-ESI relationships across geologically diverse environments is a fruitful avenue for future research.
“…The Tennant Creek rupture has been treated by multiple authors as a single rupture length for fault scaling relationships [7,8,104,139,140] and hazard mapping [119,141,142] as opposed to three separate earthquakes and associated ruptures [6,[143][144][145], a decision which significantly changes the length to magnitude ratio and slip distribution relative to an averaged epicentre location and magnitude.…”
We digitize surface rupture maps and compile observational data from 67 publications on ten of eleven historical, surface-rupturing earthquakes in Australia in order to analyze the prevailing characteristics of surface ruptures and other environmental effects in this crystalline basement-dominated intraplate environment. The studied earthquakes occurred between 1968 and 2018, and range in moment magnitude (Mw) from 4.7 to 6.6. All earthquakes involved co-seismic reverse faulting (with varying amounts of strike-slip) on single or multiple (1–6) discrete faults of ≥ 1 km length that are distinguished by orientation and kinematic criteria. Nine of ten earthquakes have surface-rupturing fault orientations that align with prevailing linear anomalies in geophysical (gravity and magnetic) data and bedrock structure (foliations and/or quartz veins and/or intrusive boundaries and/or pre-existing faults), indicating strong control of inherited crustal structure on contemporary faulting. Rupture kinematics are consistent with horizontal shortening driven by regional trajectories of horizontal compressive stress. The lack of precision in seismological data prohibits the assessment of whether surface ruptures project to hypocentral locations via contiguous, planar principal slip zones or whether rupture segmentation occurs between seismogenic depths and the surface. Rupture centroids of 1–4 km in depth indicate predominantly shallow seismic moment release. No studied earthquakes have unambiguous geological evidence for preceding surface-rupturing earthquakes on the same faults and five earthquakes contain evidence of absence of preceding ruptures since the late Pleistocene, collectively highlighting the challenge of using mapped active faults to predict future seismic hazards. Estimated maximum fault slip rates are 0.2–9.1 m Myr-1 with at least one order of uncertainty. New estimates for rupture length, fault dip, and coseismic net slip can be used to improve future iterations of earthquake magnitude—source size—displacement scaling equations. Observed environmental effects include primary surface rupture, secondary fracture/cracks, fissures, rock falls, ground-water anomalies, vegetation damage, sand-blows / liquefaction, displaced rock fragments, and holes from collapsible soil failure, at maximum estimated epicentral distances ranging from 0 to ~250 km. ESI-07 intensity-scale estimates range by ± 3 classes in each earthquake, depending on the effect considered. Comparing Mw-ESI relationships across geologically diverse environments is a fruitful avenue for future research.
“…2008; Quigley, Clark & Sandiford, 2010; Keep, Hengesh & Whitney, 2012; McPherson et al . 2014; Whitney, Hengesh & Gillam, 2016). Figure 9.A map showing the earthquake epicentres in eastern Queensland and the orientation of present-day S Hmax .…”
Section: Discussionmentioning
confidence: 99%
“…9), raising the possibility that these faults, including the Boynedale Fault and associated thrusts, are neotectonic reactivated preexisting structures. Evidence for intraplate neotectonic activity is also known from southeastern, southern and western Australia (Sandiford, 2003b;Quigley, Cupper & Sandiford, 2006;Hillis et al 2008;Quigley, Clark & Sandiford, 2010;Keep, Hengesh & Whitney, 2012;McPherson et al 2014;Whitney, Hengesh & Gillam, 2016). The long-wavelength state of stress in eastern Queensland in the vicinity of the Nagoorin Basin can be determined from analyses of petroleum well data, engineering data and focal mechanism solution of earthquakes (Rajabi et al 2017a, b).…”
Section: C Implications For Neotectonicsmentioning
Eastern Australia was affected by late Cenozoic intraplate deformation in response to far-field stress transmitted from the plate boundaries, but little is known about the intensity and pattern of this deformation. We used recently surveyed two-dimensional seismic reflection lines and aeromagnetic data, and data from the recently released Australian Stress Map, to investigate the structure of the Nagoorin Basin in eastern Queensland. The western margin of the Nagoorin beds was displaced by the Boynedale Fault, which is a NNW-striking SW-dipping oblique strike-slip reverse fault with a vertical throw ofc.900 m andc.16 km sinistral displacement. A significant part of this large sinistral displacement is interpreted to have occurred prior to late Cenozoic time. Several low-angle (<30°) thin-skinned thrusts with a flat-ramp geometry also displaced the Nagoorin beds, which are interpreted to have developed along detachment surfaces in oil shales and claystone. The Boynedale Fault is a segment within longer NNW-striking faults that include the North Pine and West Ipswich fault systems in eastern Queensland. These NNW-striking faults are potentially active, and may accommodate neotectonic thrust movement in response to the present-day NE–SW orientation of SHmax. Results of this study, in conjunction with previous information on sedimentary basins in eastern Australia, indicate that Cenozoic contractional deformation is stronger at the continental margins, possibly due to the presence of pre-existing rift-related structures.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
